Manual Toyota FSG325 (page 25 of 80) (English, Dutch, French, Italian)

458418

Zoom out

Zoom in

1/80

Nederlands Italiano

English Français

Upper threading

1. Raise the presser foot lever.

Raise the take-up lever to its highest position by

rotating the handwheel towards you.

2. Pull out the spool pin until it snaps into place.

Place a spool of thread on spool pin. (fig A)

3. Pass the thread through guide 1 . (fig B)

4. Lead the thread through either side of the tension

disc 2. (fig C)

5. Hook the thread under the guide 3. (fig D)

6. Thread take-up lever 4. (fig E)

7. Pass the thread through needle guide 5 (use left

one). (fig F)

8. Thread the needle from front to back. (fig G)

9. Pull out about 15 cm of thread and place it under

the presser foot. (fig H)

Enfilage du fil supérieur

1. Lever le levier presseur de pied-de-biche.

Lever le tendeur de fil à sa plus haute position en

tournant le volant vers vous.

2. Tirer sur le porte-bobine jusqu'à ce qu'il se mette

en place.

Placer la bobine du fil sur la tige porte-bobine.

(fig. A)

3. Passer le fil par le guide-fil 1. (fig. B)

4. Guider le fil entre les deux disques du tendeur 2.

(fig. C)

5. Accrocher-le au guide 3, de bas en haut et droit à

gauche. (fig. D)

6. Enfiler le fil par le tendeur 4. (fig. E)

7. Faire passer le fil dans le guide de l’aiguille 5

(utiliser le guide gauche). (fig. F)

8. Enfiler l’aiguille par l’avant. (fig. G)

9. Tirer environ 15 cm de fil et placer le sous le pied-

de-biche. (fig. H)

Bovendraad inrijgen

1. Zet de persvoethendel omhoog.

Breng de draadhefboom in de hoogste stand door

het handwiel naar u toe te draaien.

2. Trek de garenpen uit totdat deze op zijn plaats klikt.

Zet een klos garen op de garenpen. (fig A)

3. Geleid de draad door de geleider 1. (fig B)

4. Geleid de draad tussen de spanningsplaatjes 2

door. (fig C)

5. Haak de draad onder de geleider 3. (fig D)

6. Span de draadhefboom 4 in. (fig E)

7. Breng de draad door de naaldgeleider 5 (gebruik

de linker). (fig F)

8. Steek de draad van voor naar achter door het oog

van de naald. (fig G)

9. Trek ongeveer 15 cm draad erdoor en leg deze

onder de persvoet. (fig H)

Infilatura del filo superiore

1. Sollevate il piedino premistoffa.

Portate il tendifilo nella sua posizione più alta

facendo girare il volantino verso di voi

2. Estrarre il rocchetto finché non scatta in posizione.

Ponete un rocchetto nel portarocchetto (fig. A)

3. Fate passare il filo attraverso il guidafilo 1 (fig. B)

4. Quindi tra i due dischi della tensione 2 (fig. C)

5. Agganciatelo alla guida 3 dal basso verso l’alto e

da destra verso sinistra (fig. D)

6. Infilatelo quindi nel tendifilo 4 (fig. E)

7. Passare il filo attraverso la guida dell’ago 5

(situata a sinistra). (fig. F)

8. Ed infine nella cruna dell’ago verso il retro della

macchina (fig. G)

9. Lasciate pendere all’incirca 15 cm di filo e ponetelo

sotto il piedino premistoffa (fig. H)

Quilt60_EFNI.book Page 14 Thursday, March 30, 2006 3:44 PM

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Toyota FSG325 in the language / languages: English, Dutch, French, Italian as an attachment in your email.

The manual is 4,15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Toyota FSG325

Toyota FSG325 User Manual - German - 40 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Toyota FSG325 Manual

Product: