485654
37
Zoom out
Zoom in
Previous page
1/42
Next page
72
73
Maintenance
When the lamps are replaced, the lters should also be replaced, not cleaned.
Refer to the following guide to replace the lters.
CAUTION
Do not drop the projector on your hand or ngers while lifting the projector to
replace the lters. Doing so could injure your hand or ngers.
Note
The side and the rear lters can be pulled out from
the slots located at the bottom as shown.
1
Gently slide the lter holders in the direction
shown.
2
Lift the lter foams from all three lter
holders in the direction shown.
Remove them completely from each lter
holder and discard.
3
Place a replacement foam and press down
rmly.
4
Replace the lter holders by pushing gently
in the direction shown.
Note
When dirt and dust build up in the filter, the air circulation inside the projector is
affected and the internal temperature will rise, causing the projector to stop working or
malfunction.
Be sure the lter is inserted all the way into the slot. Leaving gaps will allow dust and
dirt to get inside the projector again.
When you purchase a new lamp, new lters are also provided. If a lter is torn or dirty,
please replace with new one. Continuing to use a ripped lter will allow dust and dirt to
get inside the projector.
Never run the projector with the lters removed. It is recommended that you clean the
Replacing the lters
Bottom
Resetting the lter time counter
After replacing the lters, the lter time counter should be reset to zero. Refer to the
following guide:
1
Press the MENU button on the control panel or remote to open the Main menu.
2
Press the
p
or
q
button to move to the [Reset] menu and press Enter.
The [Reset] menu is displayed.
3
Select [Clear lter time] using
p
or
q
and press Enter.
A conrmation box is displayed.
4
Select OK using
t
or
u
and press Enter to reset the lter time to zero.
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toshiba TDP-WX5400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toshiba TDP-WX5400 in the language / languages: English as an attachment in your email.

The manual is 7,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info