497452
13
Zoom out
Zoom in
Previous page
1/24
Next page
–12–
EN
5 Wired remote controller
This remote controller can control the operation of up to 8 indoor units.
Display section
1 Operation mode
The selected operation mode is displayed.
2 Error display
Displayed while the protective device works or a
error occurs.
3 SETTING display
Displayed during setup of the timer or other
settings.
4 TEST run display
Displayed during a test run.
5 Timer display
When an error occurs, error code is displayed.
6 Timer mode display
The selected timer mode is displayed.
7 Filter display
Reminder to clean the air filter.
8 Louver position display
Displays louver position.
9 SWING display
Displayed during up / down movement of the
louver.
10
Fan speed display
The selected fan speed mode is displayed.
11
Set temperature display
The selected set temperature is displayed.
12
Power saving mode display
Limits compressor speed (capacity) to save
energy.
In the display illustration below all the icons are shown. When the unit is in
operation, only relevant icons will be displayed.
When the leak breaker is turned on at the first time, flashes on the
display part of the remote controller.
While this icon is flashing, the model is being automatically confirmed.
Wait till icon has disappeared to use the remote controller.
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
Display
section
Operation
section
1
10
6
19
4
2
3
5
7
15
17
16
20
11
14
13
12
8 9
18
(AUTO)
(HIGH)
(MED.)
(LOW)
13
UNIT No. display
Displays the number of the indoor unit selected.
Also displays error code of indoor and outdoor
units.
14
Central control display
Displayed when the air conditioner is used under
the central control in combination with a central
control remote controller.
In case the remote controller is disabled by the
central control system, flashes.
The button operation is not accepted.
Even when ON / OFF, MODE, or TEMP. button is
pushed, and the button operation is not accepted.
(Settings made by the remote controller vary with
the central control mode. For details, refer to the
Owner’s Manual of the central control remote
controller.)
15
Remote controller sensor display
Displayed while the sensor of the remote controller
is used.
16
Pre-heat display
Displayed when the heating mode is energized or
defrost cycle is initiated.
While this icon is displayed, the indoor fan stops.
17
No function display
Displayed when the function requested is not
available on that model.
18
Self clean operation display
Displayed during self clean operation.
19
Service display
20
Operation ready display
This display appears on some models.
1
6
4
2
3
5
7
15
17
16
11
14
13
12
8 9
10
19
20
18
23-EN 24-EN
+001111055901_01EN.book Page 12 Saturday, October 8, 2011 10:44 AM
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toshiba RAV-SM566KRT-E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toshiba RAV-SM566KRT-E in the language / languages: English as an attachment in your email.

The manual is 1,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info