587677
4
Zoom out
Zoom in
Previous page
1/24
Next page
5412 3
6
385(
5(6(7
1
Press : Move the louver in the
desired vertical direction.
2
Press : Swing the air automatically
and press again to stop.
3
For horizontal direction, adjust manually.
INDOOR UNIT DISPLAY
1
Hi POWER (Green)
2
FILTER (Orange)
3
PURE (Blue)
4
TIMER (Yellow)
5
OPERATION (Green)
6
RESET button
1
Infrared signal emitter
2
Memory and preset button (PRESET)
3
Start/Stop button
4
Temperature up/down and
Timer or clock up/down button (TEMP.)
5
Mode select button (MODE)
6
Swing louver button (SWING)
7
Fan speed button (FAN)
8
One Touch button (ONE-TOUCH)
9
Set louver button (FIX)
-
8 degree celcius operation button (8°C)*
=
Economy button (ECO)
q
High power button (Hi-POWER)
w
Plasma Air Puri er button (PURE)
e
Comfort sleep button (COMFORT SLEEP)
r
Power selection button (POWER-SEL)*
t
On timer button (ON)
y
Off timer button (OFF)
u
Setup button (SET)
i
Clear button (CLR)
o
Clock setup button (CLOCK)
p
Check button (CHECK)
[
Filter reset button (FILTER)
]
Reset button (RESET)
1
PREPARATION BEFORE USE
2
Preparing Filters
1. Open the air inlet grille and remove the air lters.
2. Attach the lters. (see detail in the accessory sheet).
AIRFLOW DIRECTION
3
Note:
Do not move the louver manually by others.
The louver may automation positioning by some operation mode.
REMOTE CONTROL
4
ONE-TOUCH
5
Press the “ONE-TOUCH” button for fully automated operation that is
customised to the typical consumer preferences in your region of the world.
The customised settings control temperature air ow strength, air ow
direction and other settings to provide you alternate contact with “ONE-
TOUCH” of the button. If you prefer other settings you can select from the
many other operating functions of your Toshiba unit.
Press
: Start the operation.
* These 2 functions cannot be activated by the remote controller provided in
carton, please contact your distributor or retailer for purchasing of optional
remote controller in order to activate such functions. Its service part no. is
43T66311 (Model: WH-TA01JE). Only when using a single split outdoor unit
is connected, WH-TA01JE can be used.
AUTOMATIC OPERATION
6
To automatically select cooling, heating, or fan only operation
1. Press
: Select A.
2. Press
: Set the desired temperature.
3. Press
: Select AUTO, LOW , LOW+ , MED ,
MED+ , HIGH , or Quiet .
COOLING / HEATING / FAN ONLY OPERATION
7
1. Press : Select Cool , Heat , or Fan only .
(Fan only operation is required optional remote controller)
2. Press : Set the desired temperature.
Cooling: Min. 17°C, Heating: Max. 30°C, Fan Only: No temperature
indication
3. Press
: Select AUTO, LOW , LOW+ , MED ,
MED+ , HIGH , or Quiet .
Note: QUIET is supper low fan speed for quiet operation.
When using a multi-system outdoor unit is connected, FAN ONLY
operation cannot be used.
DRY OPERATION (COOLING ONLY)
8
For dehumidi cation, a moderate cooling performance is controlled
automatically.
1. Press
: Select Dry .
2. Press : Set the desired temperature.
AIR PURIFYING OPERATION
9
During air conditioner operation
Press
to start and stop plasma air puri er and air ionizer
operation.
The plasma air puri er and air ionizer can be activated or deactivated during
air conditioner is stopped and the air ionizer starts in conjunction with plasma
air puri er operation.
Note: The FILTER indicator (orange) turns on after PURE operation is
performed for about 1000 hours.
Hi-POWER OPERATION
10
To automatically control room temperature and air ow for faster cooling or
heating operation (except in DRY and FAN ONLY mode)
Press
: Start and stop the operation.
ECO OPERATION
11
To automatically control room to save energy (except in DRY and FAN ONLY
mode)
Press
: Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1
degree/hour for 2 hours (maximum 2 degrees increase). For heating
operation the set temperature will decrease.
TEMPORARY OPERATION
12
In case of the misplaced or discharged remote control
Pressing the RESET button, the unit can start or stop
without using the remote control.
Operation mode is set on AUTOMATIC operation,
preset temperature is 25°C and fan operation is
automatic speed.
1
4
6
7
9
=
q
e
r
i
u
]
[
3
2
5
8
-
w
t
y
o
p
385(
5(6(7
Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type) following
the (+) and (–) positions.
Clock Setup
1. Push
by tip of the pencil.
2. Press
: adjust the time.
3. Press : Set the time.
Remote Control Reset
Press
for reset.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toshiba RAS-4M27UAV at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toshiba RAS-4M27UAV in the language / languages: English, German as an attachment in your email.

The manual is 2,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info