215054
31
Zoom out
Zoom in
Previous page
1/36
Next page
Additional information
31
English
About lamp
The product’s light source is a mercury lamp that lights at increased internal pressure. Be sure to fully
understand the following characteristics of the lamp and handle it with extreme care.
• The lamp may burst with a loud noise due to impact or deterioration, or fail to light at the expiration
of its life.
• How long it takes before the lamp bursts or the life expires may vary greatly by lamp. Some may
explode shortly after first use.
Burst is likely to happen if the lamp is used after the replacement period has elapsed.
When the lamp bursts, the broken pieces of glass may get inside the product or be released
outside from the openings for ventilation.
• When the lamp bursts, a slight amount of mercury gas enclosed in the lamp along with glass dust
may be released from the openings for ventilation.
Q Immediately replace the lamp when a sign appears on the screen.
• When the replacement time approaches, a message will appear on the screen.
• The risk of explosion will increase if the lamp is continuously used without being replaced.
• Frequently check the used hours and prepare spares when the replacement time approaches.
(Refer to “Lamp Time” on . )
Q When the lamp is broken
• If glass components, including a lamp and a lens, should break, handle the broken pieces with care
to avoid injury and contact your dealer for repair service.
• In the event of lamp burst, unplug the product from the wall outlet, leave and completely ventilate
the room. Then, thoroughly clean the area around the projector and discard any edible items
placed in that area.
• When the lamp bursts, consult a doctor if glass dust or mercury gas gets into your eyes or you
breathe it.
Replacing the lamp
CAUTION: HOT SURFACE! The lamp may be very hot after use. Before replacing the lamp,
turn off the projector, unplug the power cord, and allow the projector to cool for at least 45
minutes.
The lamp unit contains mercury. Disposal of mercury may be regulated due to environmental
considerations. Dispose of the used lamp unit by the approved method for your area. Contact your local
authorities or www.eiae.org.
A lamp is consumable supplies. If used for extended periods, images will appear dark, and the lamp
could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp
depends on condition of use.) If this happens, replace it with a new one.
1. Turn off the power and unplug the power cord. Turn off all connected devices and disconnect all
other cables.
p. 28
WARNING
• If the projector is mounted on the ceiling, it is recommended to use your Toshiba dealership
when the lamp has to be exchanged.
• When replacing, always use lamp “TLPLMT70” (sold separately).
CAUTION
• If you have been using the projector, the lamp will be very hot, and may cause burn injuries.
Wait for the lamp to cool (for at least 45 minutes) before replacing it.
• If the lamp should break, please handle with care to avoid injury due to broken pieces and con-
tact your dealer for repair service.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toshiba mt700 dlp projector 720p at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toshiba mt700 dlp projector 720p in the language / languages: English as an attachment in your email.

The manual is 1,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info