481866

Toshiba e-studio 225 Manual

199
Zoom out
Zoom in
Previous page
1/228
Next page
Before Calling Service Technician 197
Before Calling Service Technician
When you encounter trouble using this equipment, check the items listed below.
General operation
Phenomenon Usual cause Countermeasure
The equipment does not
operate at all.
The power of the equipment
is not turned ON.
Turn ON the power of the equipment.
The power cable is not
plugged in securely.
Plug in the power cable securely.
The weekly timer functions
and the equipment is in the
sleep mode.
Press any of the [ENERGY SAVER] but-
ton, the [START] button and the function
switching buttons on the control panel.
The button does not respond
to my operation.
It has been a short time
since the power was turned
ON.
Wait for the completion of warm-up and
then try again.
The LCD screen is too light/
dark.
The contrast of the LCD
screen is not adjusted prop-
erly.
Adjust it with the contrast adjustment vol-
ume.
P.32 “Control panel”
A message is displayed on
the LCD screen.
The equipment has detected
an error status.
See the meaning of the message refer-
ring to the listing below.
P.174 “When This Message Appears”
“Enter DEPARTMENT
CODE” appears on the LCD
screen.
When the use of the equip-
ment is managed under
department management,
and the department code
has not been entered.
Enter your department code.
P.36 “Preparation 1 - Turning Power
ON”
P.143 “Department Code”
“Saving energy” appears on
the LCD screen.
The equipment is in the low
power mode.
The equipment enters into the low power
mode after a specified time has passed
since its last use. Copying is enabled.
“Sleep mode” appears on the
display.
The equipment is in the
sleep mode.
The equipment enters into the sleep
mode after a specified time has passed
since its last use. For how to cancel this
mode, see the following page.
P.37 “Saving energy when not in use -
Energy saving mode -”
The LCD screen is dim. The equipment is in the
super sleep mode.
The equipment enters into the super
sleep mode after a specified time has
passed since its last use. For how to can-
cel this mode, see the following page.
P.37 “Saving energy when not in use -
Energy saving mode -”
Scanning stops before it is
finished. (“Count over”
appears on the LCD screen.)
The number of pages
scanned has exceeded the
maximum value.
To copy the data scanned so far, select
“Print”. To delete them, select “Cancel
job”.
(If “Print” is grayed out, only data deletion
is possible.)
Scanning stops before it is
finished. (“Memory is full”
appears on the LCD screen.)
The built-in memory of the
equipment has become full.
To copy the data scanned so far, select
“Print”. To delete them, select “Cancel
job”.
(If “Print” is grayed out, only data deletion
is possible.)
Copying stops before it is fin-
ished. (“Clear paper output
tray: PRESS START KEY.”
appears on the display.)
Approx. 250 sheets of paper
have continuously exited and
the equipment stops copy-
ing to prevent the copied
paper from overflowing from
the tray.
Remove the paper from the receiving tray,
and then press the [START] button. Copy-
ing resumes.
Press the [CLEAR/STOP] button to end
the copy job. “Memory clear?” appears on
the LCD screen. Select “YES”, and then
press the [START] or [ENTER] button.
… 199 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toshiba e-studio 225 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toshiba e-studio 225 in the language / languages: English as an attachment in your email.

The manual is 7.93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Toshiba e-studio 225

Toshiba e-studio 225 User Manual - Dutch - 236 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info