804511
98
Zoom out
Zoom in
Previous page
1/116
Next page
5 TROUBLESHOOTING
96 Before Calling Service Technician
Image trouble
Phenomenon Usual cause Countermeasure
The density of the copy
image is light.
Toner has run out. The toner lamp blinks when toner has run
out. Replace the toner cartridge if it is
blinking.
P.89 “Replacing Toner Cartridge”
The copy density is set
lighter.
Make the density darker if you use the
manual copy density mode. Or use the
automatic copy density mode.
The transfer charger wire is
dirty.
Clean the transfer charger wire.
P.102 “Cleaning transfer charger”
The density of the copy
image is dark.
The copy density is set
darker.
Make the density lighter if you use the
manual copy density mode. Or use the
automatic copy density mode.
The copied image is stained. The Automatic Document
Feeder (optional) or the
Platen Cover is not lowered
fully.
Lower them fully to block outside light.
The original glass, platen
sheet, scanning area or
guides are dirty.
Clean them.
P.100 “Daily Inspection”
The copy density is set
darker.
Make the density lighter if you use the
manual copy density mode. Or use the
automatic copy density mode.
Highly transparent originals
such as OHP films or tracing
paper are used.
Place a blank sheet of paper, the same
size as the original or larger, over the orig-
inal.
The copy image is fogged. There is a slight gap
between the original glass
and the original.
Lower the Platen Cover or the Automatic
Document Feeder (optional) fully so that
the original will contact with the original
glass.
The copy paper is damp. Replace with dry copy paper.
The density level of the copy
image is uneven in a horizon-
tal direction.
The transfer charger wire is
dirty.
Clean the transfer charger wire.
P.102 “Cleaning transfer charger”
The copy image is partially
missing.
The size or direction of the
copy paper and the original,
or the reproduction ratio is
not set properly.
Use copy paper of the same size as the
original or set the reproduction ratio suit-
able to the copy paper size.
98


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toshiba e-STUDIO 206 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toshiba e-STUDIO 206 in the language / languages: English as an attachment in your email.

The manual is 6.33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info