807514
85
Zoom out
Zoom in
Previous page
1/92
Next page
85
DE EN
Display Cause Troubleshooting
Motor cannot be
tilted; tilt lock lever
cannot be moved
Trim rod bent Check trim rods, replace if necessary.
11.2 Error messages for Torqeedo power batteries
Display Cause Troubleshooting
E70 Over/under temperature
during charging
Remove the reason the temperature has
gone out of range. If necessary, remove
the charger unit to cool down. Switch the
battery off and on.
E71 Over/under temperature
during discharge
Remove the reason the temperature has
gone out of range. If necessary, do not
use the battery temporarily to allow it to
cool down. Switch the battery off and on.
E72 Overtemperature battery
FET
Let the battery cool down. Switch the
battery off and on.
E73 Overcurrent during
discharge
Remove cause of overcurrent. Switch the
battery off and on.
E74 Overcurrent during
charging
Remove the charger unit. Only use a
Torqeedo charger unit. Switch the battery
off and on.
E75 Activating the
Pyroswitch
Contact Torqeedo Service.
E76 Battery undervoltage Charge the battery.
E77 Overvoltage during
charging
Remove the charger unit. Only use a
Torqeedo charger unit. Switch the battery
off and on.
E78 Battery overcharge Remove the charger unit. Only use a
Torqeedo charger unit. Switch the battery
off and on.
E79 Battery electronic fault Contact Torqeedo Service.
E80 Deep discharging Contact Torqeedo Service.
Display Cause Troubleshooting
E05 Motor/propeller blocked Set the main switch to the “OFF”
position. Release the blockage and turn
the propeller one turn further by hand.
Reconnect the motor cable.
E06 Voltage at motor too low Low battery state of charge. If necessary,
the motor can be driven slowly from the
stop position.
E07 Overcurrent at the motor Continue driving with low power. Contact
Torqeedo Service.
E08 Circuit board
overtemperature
After a short waiting time (approx. 10
minutes), the motor can be operated
slowly. Contact Torqeedo Service.
E21 Faulty calibration of
tiller / remote throttle
Set forwards/reverse motion
E22 Magnetic sensor
defective
Set forwards/reverse motion
E23 Value range wrong Set forwards/reverse motion
E30 Motor communication
error; error in the power
supply to the motor
Contact Torqeedo Service;
Check that the main switch is in the “ON”
position.
E32 Tiller communication
error / remote throttle
Check the plug connections of the data
cables and cables.
E33 General communication
error
Check the plug connections and the
cables. Switch the motor off and on again.
E34 Emergency kill switch or
kill switch actuated
Make sure that the cause of the error has
been eliminated, set the emergency kill
switch or the kill switch to the position for
normal operation and restart the system.
E43 Battery empty Charge the battery. If necessary, the
motor can be driven slowly from the stop
position.
Other error codes Defect Contact Torqeedo Service.
No indication in
the display
No voltage or defective Check power source, main fuse and
main switch. If the power supply is okay:
Contact Torqeedo Service.
85


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Torqeedo Cruise 3.0 R-T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Torqeedo Cruise 3.0 R-T in the language / languages: English, German as an attachment in your email.

The manual is 3.6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Torqeedo Cruise 3.0 R-T

Torqeedo Cruise 3.0 R-T User Manual - Dutch, Danish - 92 pages

Torqeedo Cruise 3.0 R-T User Manual - French, Italian - 96 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info