659586
17
Zoom out
Zoom in
Previous page
1/24
Next page
17
Servicing the Spark Plug
Check the spark plug after every 25 operating hours. Use a
Champion RJ19LM spark plug or equivalent.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Fig. 7).
3. Clean around the spark plug and remove it from the
cylinder head.
Important Replace a cracked, fouled, or dirty spark
plug. Do not clean the electrodes because grit entering the
cylinder could damage the engine.
4. Set the gap on the new plug to 0.030 in. (0.76 mm)
(Fig. 19).
986
1
Figure 19
1. 0.030 in. (0.76 mm)
5. Install the spark plug and the gasket seal.
6. Torque the spark plug to 15 ft-lb (20 Nm).
7. Connect the wire to the spark plug.
Adjusting the Self-propel Drive
Cable
Whenever you change the handle height, install a new
self-propel cable, or the traction drive belt slips, adjust the
self-propel drive cable.
1. Stop the engine and wait for all moving parts to stop.
2. Remove the cover.
3. Loosen the cable support nut (Fig. 20).
m-4205
1
2
3
4
Figure 20
1. Cable jacket
2. Cable support
3. Nut
4. Upper handle
4. Push the drive bracket down until it contacts the lawn
mower, then hold it in place (Fig. 21).
m-4273
1
2
Figure 21
1. Drive bracket 2. Push here
5. With the upper handle pushed back as far as possible
and while holding the drive bracket down, pull the cable
jacket down (toward the lawn mower) until there is no
slack in the cable (Fig. 20).
6. Tighten the nut on the cable support (Fig. 20).
7. Release the drive bracket.
8. Install the belt cover.
Lubricating the Wheels
After every 25 operating hours or at the end of the season,
lubricate the front and the rear wheels.
1. Apply 2 or 3 drops of light oil on the inside of the front
wheels and on the outside of all the wheel bolts.
2. Spin the wheels to distribute the oil into the bushings.
3. Wipe up any excess oil.
4. Move the rear wheel cutting height levers to the C
setting.
5. Wipe the grease fittings with a clean rag (Fig. 22).
1
276
Figure 22
1. Grease fitting
6. Install a grease gun onto each fitting and gently apply 2
or 3 pumps of #2 multi-purpose lithium base grease.
Important Applying grease using excess pressure may
damage the seals.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toro 20781 - 53 cm Super Recycler at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toro 20781 - 53 cm Super Recycler in the language / languages: English as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Toro 20781 - 53 cm Super Recycler

Toro 20781 - 53 cm Super Recycler User Manual - German - 24 pages

Toro 20781 - 53 cm Super Recycler User Manual - Dutch - 24 pages

Toro 20781 - 53 cm Super Recycler User Manual - French - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info