Manual Topro Odysse M (page 11 of 24) (English, German, Dutch, Norwegian)

691207

Zoom out

Zoom in

1/24

ODYSSÉ

www.topro.no10

EN EN

Before mounting the rear wheels, make sure the parking brakes are not activated. After mounting the wheels,

check that the brakes are functioning properly. Adjust them if necessary (see paragraph Adjusting / checking

and maintaining the brakes).

Dismounting the wheels: Make sure the parking brakes are not activated (applies to the rear wheels only).

Then push down the red button on the hub A and slide the wheel o the axle B while still pushing the button.

Dismounting the front forks: Please note: The forks can only be dismounted when the rollator is completely

folded. Do not use force, as this may damage the parts. Lift the lock hook for the fork bolt C by using a nger,

a at screwdriver or similar. Take the wheel with fork D o while lifting the lock hook up and outwards.

Mounting the front forks: Please note: The forks can only be mounted when the rollator is completely folded.

Do not use force; this may damage the parts. Make sure to choose the correct wheel for each side. The forks

are marked with R (right) and L (left). The fork should turn inwards and backwards and the wheel outwards.

Grip the front wheel and fork E. Rotate the fork so that the sloping side of the bolt turns forwards in the rol-

lator's driving direction F. Lift the lock hook for the fork bolt C up and outwards while you push the fork bolt

completely into the fastening point/hole G. Thereafter push the lock hook for the fork bolt in and downwards

H until you hear a “click”. Tip: Lubrication of the lock hook with grease is advised to ensure smooth mounting

and dismounting of the wheels.

Unfolding / folding

Unfolding: Loosen the clip of the strap that goes from the shopping bag around the lower rollator tubes A.

Stand behind the rollator and grip both handlebars. Gently lift the rear part of the rollator slightly from the

oor B and then push the rear wheels down, one by one, to release the inner locking mechanism C. Then lift

the handles upwards D until you hear a clicking sound and the red indicators in front of the connection parts

are not visible E. Loosen the lock clamp that is over the seat bars F. Press the seat bars down and out G. The

side frames will slide apart. Press down the seat bars. You will hear a clicking sound. The rollator is now locked

in its open position. Close the strap A behind the cross beams to avoid it from hooking up.

Folding: Adjust the handlebar tubes to the lowest position, so that the rollator can t into the transport

bag (see paragraph Lowering and height adjusting the handles). Pull the strap on the seat H and press the

side frames together I. Lock the clamp J over the seat bars. Grip the oval shaped releaser on both sides of

the rollator K with your thumbs at the front. Push the release handles down and lead the handlebars toward

the rear wheels L until they lock and you can hear a “click”. Please note: The brake handles have to be situated

behind the tilt function to ensure the rollator is in the locked position.

Lowering and height adjusting the handles

Lowering: Unscrew the lock wheel for the brake handles A (approx. 4–5 turns). Push the handlebar tubes

down until they stop B. Tighten the lock A again.

Height adjusting: Unscrew the lock for the brake handles A (approx. 4–5 turns). Adjust the handlebar tubes

to a suitable height then pull them slightly up and down C until you hear a clicking sound. Tighten the lock

A again. Adjust both handlebars to the same height. Be aware of the maximum height marked on the tubes.

It is recommended that the handlebars are set to the same height as your wrists when your arms are hanging

alongside your body.

Adjusting / checking and maintaining the brakes

Adjusting / checking: Loosen the nut A beside the brake. Tighten the brake wire B with the adjustment

screw C. Adjust the brake block D as close as possible to the inner drum brake, and then tighten the nut A.

Turn the wheel around to check that the brake block is not touching the wheel.

Maintaining: Clean the brake block D and the brake spring E frequently. The wheels and brakes can be

replaced if they are worn or damaged.

Using the brakes

Make sure the brakes work before each trip. Each brake handle A works on each of the rear wheels.

Wrong use can cause unsafe situations and damage to the rollator: The rollator must not be driven or pushed

with force when the parking brakes are on or when the wheels are partly locked using the brakes. This indicates

incorrect use and can cause wear and tear, which makes the tires and brake quality weaker.

Parking brakes: Push both brake handles A down until they lock. Both rear wheels are now locked. Squeeze

both brakes handles upwards to release the parking brakes.

Driving brakes: Pull both brake handles B upwards to reduce speed. Do not use continuously while the

rollator is in motion.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Topro Odysse M in the language / languages: English, German, Dutch, Norwegian as an attachment in your email.

The manual is 4,94 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Topro Odysse M Manual

Product: