Manual Topcom Twintalker 3500 (page 2 of 22) (English, German, Dutch, French)

469818

Zoom out

Zoom in

1/22

5.8. Using rechargeable batteries.

Important: Do not charge this unit using an AC/DC ADAPTER with regular

“AAA” alkaline batteries installed. Only use the optional AC/DC

ADAPTER with “AAA” rechargeable batteries (not included).

To use the PMR with an AC/DC ADAPTER and rechargeable batteries do the

following:

1. Insert four (4) “AAA” rechargeable batteries (not included).

2. Plug the 7,5 V DC / 200 mA ADAPTER (not included) into the EAR/MIC/

CHARGER JACK on the top of the unit and turn it ON by pressing the

POWER button.

NOTE: The unit cannot transmit calls while the batteries are being charged. It

takes approximately 8 to 10 hours to fully charge the batteries..

.Headset use

You can operate the PMR using a headset (not included).Plug the headset into

the EAR/MIC jack (5).

5.9. Sending Call Tones

You can use Call Tones to alert the other user to identify yourself. You can also

use Call Tones to signal the beginning or the end of a transmission.

1. Press and release the CALL button. The CALL TONE continues for 3

seconds.

2. Your CALL TONES will transmit to nearby receivers set to the same

channel.

6. SPECIFICATIONS

Channels

CTCSS Sub-channel

Output Power (TX)

Range

8 Channels

38 for each Channel

Output Power :0.5W (Maximum)

Up to 3 Km (open ﬁeld)

2,5 mm 3,5 mm

7. SAFETY INSTRUCTIONS

7.1. Damage antenna.

Do not use any communicator that has a damaged Antenna. If a damaged

antenna comes in contact with the skin, a minor burn may result.

7.2. Batteries.

As batteries can cause property damage and/or bodily injury such as burns if

conductive material such as jewelry, keys or beaded chains touches exposed

terminals. The material may complete an electrical circuit (short circuit) and

become quite hot. Exercise care in handling any charged battery, particularly

when placing it inside a pocket, purse or other container with metal objects.Do

not replace or charge batteries in a potentially explosive atmosphere. Contact

sparking may occur while installing or removing batteries and cause an

explosion.

7.3. For vehicles with air bag.

Do not place your Communicator in the area over an air bag or in the air bad

deployment area. Air bags inﬂate with great force. If a communicator is placed

in the bag deployment area and the air bag inﬂates, the communicator may be

propelled with great force and cause serious injury to the occupants of vehicle.

7.4. Potentially Explosive Atmospheres.

Tu rn your communicator off when in any area with a potentially explosive

atmosphere, unless it is a type speciﬁcally qualiﬁed for such use. Sparks in

such areas could cause an explosion or ﬁre resulting in bodily injury or even

death.

7.5. Blasting caps and areas

To avoid possible interference with blasting operation, turn your communicator

off near electrical blasting caps or in a ‘blasting area’ or in areas posted : ‘Turn

off two way radio’. Obey all signs and instructions.

Note : Areas with potentially explosive atmospheres are often, but not always,

clearly marked. They include fueling areas such as below deck on boats, fuel

or chemical transfer or storage facilities; areas where the air contains

chemicals or particles, such as grain, dust or metal powders; and any other

area where you would normally be advised to turn off your vehicle engine.

7.6. Electromagnetic Interference/Compatibility:

Nearly every electronic device is susceptible to electromagnetic interference

(EMI) if inadequately shielded, designed or otherwise conﬁgured for

electromagnetic compatibility.

Tu rn your unit OFF in any facilities where posted notices instruct you to do so.

Hospitals or health care facilities may be using equipment that is sensitive to

external RF energy.

Tu rn your unit OFF when on board an aircraft when instructed to do so. Any

use of the unit must be accordance with airline regulations or crew

instructions.

8. CARE AND MAINTENANCE

To clean the unit, wipe with a soft cloth dampened with water. Don’t use a

cleaner or solvents on the unit; they can harm the case and leak inside,

causing permanent damage. Battery contacts may be wiped with a dry lint-free

cloth. If the unit gets wet, turn it off and remove the batteries immediately. Dry

the BATTERY COMPARTMENT with a solf cloth to minimize potential water

damage. Leave the cover off the BATTERY COMPARTMENT overnight or until

completely dry. Do not use the unit until completely dry.

9. WARRANTY

This equipment comes with a 36-month warranty. The warranty will be

honoured on presentation of the original or a copy bill or receipt, provided the

date of purchase and the unit type are indicated.

During the time of the warranty Topcom will repair free of charge any defects

caused by material or manufacturing faults. Topcom will at its own discretion

fulﬁl its warranty obligations by either repairing or exchanging the faulty

equipment.

Any warranty claims will be invalidated as a result of intervention by the buyer

or unqualiﬁed third parties.

Damage caused by inexpert treatment or operation, and damage resulting

from the use of non-original parts or accessories not recommended by

Topcom is not covered by the warranty.

The warranty does not cover damage caused by outside factors, such as

lightning, water and ﬁre, nor does it apply if the unit numbers on the equipment

have been changed, removed or rendered illegible.

Note: Please do not forget to enclose your receipt if you return the equipment.

5.4. Button Lock

Press and hold the MENU button ( ) for 5 seconds to activate or deactivate

the BUTTON LOCK mode. The BUTTON LOCK icon is displayed on the LCD

Screen.Press and hold the MENU button ( ) again to deactivate BUTTON

LOCK

5.5. VOX Selection

The PMRS is capable of voice activated (VOX) transmission. In VOX mode, the

radio will transmit a signal when it is activated by your voice or other sound

around you. VOX operation is not recommended If you plan to use your radio

in a noisy or windy environment.

1. Press the MENU button ( ) 3 times, the VX icon will blink on the LCD

Screen.

2. Press the UP button ( ) to turn the VOX feature ON, or press the DOWN

button ( ) to turn the VOX feature OFF.

3. In the VOX mode, the VX icon will be displayed.

4. To conﬁrm your selection and return to the NORMAL mode, press the TALK

button.

5. To conﬁrm and shift to the next option, press the MENU button.

NOTE: To save power, the unit will not turn ON the LCD Screen light when in

the VOX mode.

5.6. Channel Scan

CHANNEL SCAN performs searches for active signals in an endless loop from

channel 1 to 8.

1. Press the SCAN S button to activate CHANNEL SCAN.

2. When an active signal (one of 8 channels) is detected, CHANNEL SCAN

pauses and you will hear the active signal.

3. Press the TALK button to communicate through the active signal channel

and CHANNEL SCAN is deactivated.

4. When an active signal (one of 8 channels) is detected, press the UP ( ) or

DOWN button ( ) to bypass the current channel and continue to search for

another active channel

5. Press the SCAN button to deactivate CHANNEL SCAN mode.

5.7. Battery Charge Level/Low Battery Indication

• The BATTERY CHARGE LEVEL is indicated by the number of squares

present inside the BATTERY icon on the LCD Screen.

• When the BATTERY CHARGE LEVEL is low, the BATTERY icon will ﬂash

to indicate that the batteries need to be replaced or recharged.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Topcom Twintalker 3500 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,12 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Topcom Twintalker 3500 Manual

Product: