Manual Topcom RC-6405 - Twintalker (page 3 of 124) (All languages)

719691

Zoom out

Zoom in

1/124

Twintalker RC-6405

7 Using a PMR device

To communicate between PMR devices they need to be set all on the same channel and CTCSS/

DCS code (see chapter “13.7 CTCSS (Continious Tone Coded Squelch System) / DCS (Digital

Coded Squelch)” and within receiving range (up to max. 10 km in open field). Since these

devices use free frequency bands (channels), all devi

ces in operation share these channels(total

8 channels). Therefore, privacy is not garanteed. Anybody with a PMR set to your channel can

overhear the conversation. If you want to communicate (transmitting a voice signal) you need to

press the

PTT

-button

Once this button pressed, the device will go into transmit mode and you can speak into the

microp

hone. All other PMR devices in range , on the same channel and in standby mode (not

transmitting) will hear your message. You need to wait until the other party stops transmitting

before you can reply to the message. At the end of each transmission the unit will send a beep

if the Roger Beep is enable (see chapter “13.12 Roger Beep On/Off” ). To reply, just press the

PTT

-button

and speak into the microphone.

If 2 or more users press the - button at the same time the receiver

will receive only the stongest signal and the other signal(s) will be

supressed. Therefore you should only transmit a signal

(press - button when the channel is free.

PTT

The range of radio waves is strongly affected by obstacles such as

buildings, concrete/metal structures, the unevenness of the landscape,

woodland, plants, … This implies that the range between two or more PMR's

may in some extreme cases be restricted to a maximum of a few tens of

meters. You will soon notice that PMR works best when there is a minimum

of obstacles between users.

8 Included in the package

• 2 x Twintalker RC-6405

• 2 x Desktop Charger

• 2 x Power adapter

• 8 x AAA NiMh batteries

• User guide

• Card with service address and Hotline

9 Getting started

9.1 Installing/Removing the Belt Clip

1. To remove the belt clip from the unit, push the belt clip

(B) towards the antenna,

while pulling the clip tab (A).

2. When re-installing the belt clip, a click indicates the belt

clip

is locked into position

9.2 Battery Installation

1. Remove the belt clip (see chapter “9.1 Installing/Removing the Belt Clip”)

2. Lift the battery door by gently pushing the

door clip (C) using your finger nail.

3. Install the NiMh batteries. Make sure that the polarity of the NiMh batteries is correct.

4. Close the battery door.

5. Re-install the belt clip

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Topcom RC-6405 - Twintalker in the language / languages: All languages as an attachment in your email.

The manual is 50,22 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Topcom RC-6405 - Twintalker Manual

Product: