- You can see the list of the MSN numbers assigned to this handset
- Select the MSN number which you want to be send out (set as default).
- Press OK to switch over activate (✔ appears on the display)/deactivate ( - ).
- Press ESC to leave the setting.
8.4. Call Restriction
For each handset you can set up a restriction.
You can decided if the user can operate the handset without limitations for calls (EXTERNAL FREE) or
with limitation (EXTERNAL BLOCKED). Incoming calls are indicated in both cases.
You can further decide if only internal call are possible -incoming and outgoing call are locked- (ONLY
INTERNAL).
- Press MENU when the unit is in standby mode..
- Select BASE SETTING by using the UP- and DOWN keys.
- Press OK to confirm
- Enter the Base Pin code BS_PIN:?
- Press OK to confirm.
- Select HS CONFIG by using the UP- and DOWN keys.
- Press OK to confirm.
- Select RESTRICTIONS by using the UP- and DOWN keys.
- Press OK to confirm.
- Select the desired handset by using the UP- and DOWN keys.
- Select OPT.
- Select the desired restriction by using the UP- and DOWN keys.
NO BLOCK: NO RESTRICTIONS
EXT. BLOCKED: NO OUTGOING EXTERNAL CALL
INT. ONLY: ONLY INTERNAL CALLS
- Press OK to confirm.
- Press ESC to leave the setting
Note: If you set a handset to Internal only you can not receive incoming external calls. Therefore the handset will not
ring anymore on incoming MSN number even if this MSN is assigned to this handset.
8.5. Remove Handset
With this function you can remove a handset from the base station. Consequently, the handset cannot
be used on this system and must be re-subscribed.
- Press MENU when the unit is in standby mode..
- Select BASE SETTING by using the UP- and DOWN keys.
- Press OK to confirm
- Enter the Base Pin code BS_PIN:?
- Press OK to confirm.
- Select HS CONFIG by using the UP- and DOWN keys.
- Press OK to confirm.
- Select REMOVE HS by using the UP- and DOWN keys.
- Press OK to confirm.
- Select the desired handset by using the UP- and DOWN keys.
- Press OK to confirm.
- The display show DELETE
- Press OK to confirm.
- Press ESC to leave the setting