10
preset the function values for counting down. Press and release the MODE button until “SCAN” does not
appear on display, the meter will enter setting mode. Use SET and RESET buttons to input the values, and
press MODE button to confirm. Or, just press the MODE button to skip the setting and move on to the next
function. After all the desired settings are chosen, begin pulling on the HANDLEBAR (5) to start the workout.
Time (1:00 to 99:00) Count (10 to 9990) Distance (100 to 9900 meter) Calories (10 to 9990 Kcal)
NOTE:
1. You may preset values for several functions. The preset function values will start to count down. When
you complete one of the preset functions, the value of this completed function will start to count up,
while the other preset functions will continue to count down.
2. The Meter will shut off automatically after 4 minutes of inactivity. All function values will be kept. You
can continue to work out with these function values. Or, press the RESET or MODE button and hold it
down for two seconds to reset all functions to zero.
HOW TO INSTALL AND REPLACE BATTERIES: AA Batteries
1. Open the Battery Door on the back of the meter.
2. The meter operates with two AA batteries (1.5V each), the batteries are not included. Refer to the illustration to
install or replace the batteries.
NOTE:
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery with another type of battery.
3. Rechargeable batteries are not recommended.
4. Ultimate disposal of battery should be handled according to all state and federal laws and regulations.
5. Do not dispose of batteries in fire.
