720257
6
Zoom out
Zoom in
Previous page
1/40
Next page
FT91N
V. 05 09/08/2019 6 ©Velleman nv
8. Thermostatic Ignition
Prior to using the gas heater for the first time or after the gas heater has been stored for a
long time, we recommend, with the pressure regulator closed, repeatedly pressing the buttons
a few times.
Open the gas flow by turning the lever of the pressure regulator toward the marking.
Switching On the Gas Heater
Fully turn the thermostat button in an anticlockwise direction until it reaches its maximum
position.
Fully press the button for 15 seconds, and then press the button 2 or 3 times.
The pilot light will burn. Repeat the steps above if the pilot light dies out.
Keep pressing the button for 20 seconds to allow the thermocouple to heat. Release and
leave the thermostat button at its maximum position for 10 minutes. When the room has
reached the ideal temperature, turn the thermostat button in the desired position.
9. Cleaning and Maintenance
In the unlikely event of technical problems or should you need spare parts, please contact your
dealer.
Periodic maintenance must be done by a qualified technician only.
We recommend servicing your gas heater every two years by a qualified technician.
Regularly check the pilot light, which must burn steadily.
Check if the gas hose must be replaced. If so, contact your dealer for a new hose and
connect as described in chapter Starting the Gas Heater.
We recommend cleaning your gas heater only with a closed pressure regulator, after the
gas heater has cooled down completely, and using non-abrasive cleaning agents.
Store an unused gas heater in a dry and dust-free room, covered with a plastic sheet or
cloth.
10. Troubleshooting
The gas heater does not switch on.
Check if the gas cylinder is filled with gas and if the pressure regulator is correctly
connected and opened.
Make sure the gas hose is connected. Please follow the instructions correctly.
Presence of air in the gas cylinder. Keep pressing the button until the pilot light burns and
the gas heater is switched on. Next, turn the thermostat button to the maximum position.
The gas cylinder has been exposed to low temperatures. Apply hot and damp cloths to the
upper part of the gas cylinder to enhance the gasification and the normal gas output.
The gas heater switches off.
If the gas heater switches off after the switch-on procedure, simply repeat the procedure
minding every step described in the instructions.
If the gas heater switches off after 30 minutes of burning, it might be due to a little-
ventilated room. Air the room where the gas heater is being used and switch on the gas
heater.
If the gas heater switches off within 30 minutes of burning, check for draughts and verify
the gas level in the cylinder.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toolland FT91N at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toolland FT91N in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 0,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info