Manual Tomy TD300 Digital (page 3 of 33) (English, German, Dutch, French, Italian, Spanish)

549759

Zoom out

Zoom in

1/33

• PAGING

Locate a lost Parent Unit by pressing the

button on the Baby Unit 3 times in quick succession and the Parent Unit

will sound a 1-minute long alarm. To silence the alarm, press any button on the Parent Unit. Please note that the

paging feature will only work when both units are switched ON and monitoring as normal.

• BELT CLIP

Locate the rubber cover on the back of the Parent Unit and the belt

clip attachment supplied. Remove and carefully store the rubber cover,

then line up the belt clip’s guiding pins (image 1), insert the

clip in Position and turn 90 degrees in a clockwise direction

to position . Alternatively, the belt clip can be orientated

so that you can wall mount or hang your Parent Unit.

In which case, line up the belt clip’s guiding pins (image 2),

insert the clip in position and turn 90 degrees in a clockwise

direction to position .

• INDEPENDENT NIGHTLIGHT

As your baby grows older you can use the Nightlight without monitoring and without the need for the Parent Unit.

With the Baby Unit switched OFF, press and hold the

button and the Nightlight will illuminate. The

button will glow

red (instead of the usual green), indicating that the monitor is not switched ON. Press the

button again to switch off.

• ACCESSORIES; TOMY’S MOVEMENT SENSOR PAD MONITOR AND ADDITIONAL PARENT UNITS

For extra reassurance Tomy’s Movement Sensor Pad Monitor and/or an additional Parent Unit from either the Tomy

Digital or Digital Plus models can be added to your Monitor. For further details please visit our website: www.tomy.eu

• CARING FOR YOUR MONITOR

Do not immerse any parts in liquids. Do not place in direct sunlight.

Periodically examine product for signs of damage

to electrical parts and do not use until damage has been properly repaired.

Always remove batteries from the Baby Unit if

using the mains adaptor for long periods of time.

• GUARANTEE

We guarantee your monitor against manufacturing defects for 2 years from the date of purchase on production of

a valid receipt. In the rst instance of a manufacturing defect, we recommend that you return your monitor to its

place of purchase. If this does not satisfactorily resolve your problem, please refer to www.tomy.eu for further advice.

Full terms and conditions can be found on our website: www.tomy.eu

• TECHNICAL SPECIFICATIONS

- Power Supply: Mains adaptor rating: PRI: 230V~50Hz SEC: 6V

300mA.

- Batteries: Parent Unit - Rechargeable 850mAh 2.4V Ni-MH battery (included).

Baby Unit - Requires 4 x 1.5V AA (LR6) batteries.

- Operating Range: 350m in optimum ‘open eld’ conditions.

- Operating Temperature: 0 - 50ºc.

- Frequencies: 1880~1900MHz.

• VOLUME CONTROL

Adjust the volume from zero (mute) to level 10 (max) by moving the thumb wheel clockwise to increase or anti-

clockwise to decrease.

• SOUND LEVEL LIGHTS DISPLAY

The Sound Level Lights Display on your Parent Unit reacts to the sounds of your baby. The louder your baby, the more

lights illuminate on the display. You can lower the volume of the Parent Unit whilst still watching out for baby, ideal

for when you’re relaxing or entertaining.

• SOUND ACTIVATED MONITORING

For those quiet moments or when your baby is a little older you may not want to hear every sound in your baby’s

room. Your Baby Monitor has a Sound Activated Monitoring mode, a feature that only captures sounds above a pre-

set threshold, for example a cry rather than a gurgle.

Select Sound Activated Monitoring by pressing the

button on the Parent Unit. The Parent Unit will mute

15 seconds after your baby settles. Every time your baby’s sounds rise above the threshold this feature will be

interrupted instantly and normal sound monitoring will continue until your baby settles again.

• 2-WAY TALKBACK

For that little extra reassurance and convenience, your monitor has a 2-Way Talkback feature that allows you

to speak to your baby. Press and hold down the

button on the side of the Parent Unit to activate and speak

to your baby.

• TEMPERATURE GAUGE

To check the ambient temperature of your baby’s room simply press and hold the button on your Parent Unit. The Sound

Sensitive Light Display shall be temporarily suspended and replaced with the ambient temperature in your baby’s room.

Please note the temperature gauge is marked in 2°C intervals. Should the ambient temperature fall in-between

intervals then the lights above and below will illuminate (e.g for 27°C the 26°C and 28°C lights will illuminate).

• NIGHTLIGHT

Your Baby Unit has a soft glow Nightlight that can be activated by pressing the

button on your Baby Unit or

remotely from your Parent Unit.

To extend the Baby Unit’s battery life the Nightlight will only operate for 5 minutes at a time. For unlimited use

switch to mains power using the adaptor provided.

To switch off the Nightlight, press the

button on your Baby Unit or on the Parent Unit.

To use the Nightlight without monitoring, please refer to the ‘Independent Nightlight’ section within this booklet.

• FEATURES AND FUNCTIONS

GBGB

1. Belt Clip

2. Wall Mount

4 5

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Tomy TD300 Digital in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 5,25 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Tomy TD300 Digital Manual

Product: