Manual Timex W223 (page 8 of 117) (English, German, Dutch, French, Italian, Polish, Portuguese, Turkish, Spanish)

466713

Zoom out

Zoom in

1/117

ENGLISH 222-095001-03

SETTING THE DATE

1. PULL the crown out to the 1st position “B”.

2. Turn the crown clockwise to set the date. *If the date is set between the

hours of around 9:00 PM and 1:00 AM, the date may not change on the

following day.

3. After the date has been set, push the crown back to the normal position “A”.

OPERATING THE CHRONOGRAPH FUNCTION (WILL MEASURE UP

TO 1 HOUR)

1. PRESS pusher “A” to start timing.

2. PRESS pusher “A” to stop timing.

3. PRESS pusher “B” to reset.

RECALIBRATING THE CHRONOGRAPH SECOND HAND

(IF IT DOES NOT RETURN TO THE 12 POSITION AFTER RESET

OR AFTER CHANGING THE BATTERY)

1. PULL the crown out to the 2nd position “C”.

2. PUSH pusher “A” to move the Chronograph second hand one increment

forward (holding the pusher in continually will rapidly advance the hand).

3. Once the Chronograph second hand is in the 12 position, PUSH the crown in

to the normal position “A”. The second hand in the sub-dial at the 6 position

will begin to move.

ELAPSED TIME RING

If your watch is equipped with a rotatable outer ring on the face, with numbers

corresponding to minutes, you can use this Elapsed Time Ring to time an

activity from the start, or to mark the ending time for the duration of an activity.

TO TIME AN ACTIVITY FROM THE START:

Set the Start/Stop triangle at the time (hour or minute) when you start the

activity (As shown on the left in the illustration shown below). At completion,

you can see how long the activity took.

TO MEASURE THE TIME REMAINING:

Set the triangle to the hour or minute position when you wish to complete the

activity, and check the watch periodically for progress towards that goal.

In the illustration shown on the previous page on the right you can stop when

the minute hand reaches the 20 minutes past the hour position.

TACHYMETER RING

The tachymeter feature can be used to measure speed in miles per hour (MPH),

nautical miles per hour (knots) or kilometers per hour (KPH) using the sweep

second hand and the scale on the wall above the watch face. You need to

know the actual distance you are covering in miles or km.

Start the chronograph with the second hand at zero (the twelve o’clock

position). Within the ﬁrst minute, the second hand will point to the rate for a one-

mile (or one kilometer) course: if it takes 45 seconds, the hand will point to 80 at

that position – 80 MPH or 80 KPH.

If within the ﬁrst minute, a distance greater than one mile or kilometer is

covered, multiply the tachymeter number by the distance to get the actual rate:

if you went 1.2 miles in 45 seconds, multiply the 80 by 1.2 – 96 MPH.

COMPASS RING

If your watch is equipped with a movable ring around the dial marked at the

letters “N”, “E”, “W”, “S” (for the four compass directions) or compass degrees,

you can use this feature to ﬁnd an approximate compass directional reading.

1. Lay the watch on a ﬂat surface, or hold it so that the face is parallel to the

ground.

2. Locate the sun and point the hour hand at the sun.

3. In the A.M., rotate the ring until the “S” (south) marker is halfway between

the hour hand and 12:00 (after the hour hand or within the shortest distance

between the hour hand and 12:00).

4. In the P.M., rotate the ring until “S” is before the hour hand and halfway

between the hour hand and 12:00.

12 1

HOW TO ADJUST BRACELET

(Variations of the following bracelet sections apply to all watch models).

SLIDING CLASP BRACELET

1 Open locking plate.

2. Move clasp to desired bracelet length.

3. Exert pressure while holding locking plate and slide clasp back and forth until

it engages in grooves on underside of bracelet.

4. Press locking plate down until it snaps closed. Clasp can be damaged if

excessive force is used.

FOLDOVER CLASP BRACELET

1. Find spring bar that connects bracelet to clasp.

2. Using a pointed tool, push in spring bar and gently twist bracelet to

disengage.

3. Determine wrist size, then insert spring bar in correct bottom hole.

4. Push down on spring bar, align with top hole and release to lock in place.

Fig. 2Fig. 1 Fig. 3

BRACELET LINK REMOVAL

REMOVING LINKS:

1. Place bracelet upright and insert pointed tool in opening of link.

2. Push pin forcefully in direction of arrow until link is detached (pins are

designed to be dicult to remove).

3. Repeat until desired number of links are removed.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Timex W223 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 8.9 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Timex W223

Timex W223 User Manual - English, Dutch - 277 pages

Timex W223 User Manual - Dutch - 29 pages

Timex W223 User Manual - French, Italian - 277 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Timex W223 Manual

Product: