800431
14
Zoom out
Zoom in
Previous page
1/36
Next page
14 OBL906-05
• Even when there is no power the bike rack may be closed by hand, close all straps. Secure
also the bike rack with the strap of 2.5m to the baseframe.
• If the bike rack stops at the start of the opening of the THULE LIFT, gently push the bike
rack until movement recommences.
• Always drive with a closed THULE LIFT and always x the outer bike to the frame by
means of an included strap .
• You can install a switch inside the vehicle that cuts off the power, preventing undesired
opening of the LIFT.
The electronic device may only be installed by qualied personnel from a specialist company
(in Germany in accordance with VDE 0100, Part 721). The following information is intended for
specialists who are familiar with the guidelines and safety precautions to be applied.
Caution!
Safety instruction relating to danger emanating from electrical currents or voltage: failure to
observe this instruction can cause material damage or personal injury and impair the proper
functioning of the device.
The manufacturer will not be held liable for claims for damage resulting from the following:
• Faulty assembly or connection
• Damage to the appliance resulting from mechanical inuences and excess voltage
• Alterations to the device without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
Warning!
To prevent short circuits, always disconnect the negative terminal of the electrical system before
working on the vehicle. If the vehicle has an additional battery, its negative terminal should also
be disconnected.
Warning!
Inadequate supply cable connections could result in short circuits with the consequence that:
• Cable res occur
• The airbag is triggered
• Electronic control devices are damaged
• Electric functions fail (indicators, brake light, horn, ignition, lights)
INSTALLING & CONNECTING THE POWER CABLE
Thule NV recommends that you connect the power cable to the fuse box or terminal block and
not directly to the battery;
Choose the safest and shortest installation route for the power cable.
Shorten the power cable as required.
Caution
Only use cable clips that are suitable for the diameter of the power cable for the connection to
the fuse box, terminal block or battery. If the wrong terminals are used, it could cause a voltage
drop and increase heat formation at the terminal.
Use the correct fuse to the connection with the vehicle’s power supply according the wiring
diagram and according EN 1648-1 & EN 1648-2.
Caution
Installing the wrong fuse can cause cable re in case of a short circuit or malfunction!
If the length of the supplied power cable is not sufcient, the connection cable must be replaced
with a new connection cable with a larger cable diameter.
Thule NV is not responsible for any misprints.
This instruction may be changed without prior notice. We do not accept responsibility for any
possible errors in the content.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thule 307369 Lift V16 - 12V motor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thule 307369 Lift V16 - 12V motor in the language / languages: All languages as an attachment in your email.

The manual is 4.46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info