582506
8
Zoom out
Zoom in
Previous page
1/15
Next page
8
Montage und Justierung des Tonabnehmers
Anstelle eines eingebauten Tonabnehmers kann ein an-
derer 1/2 Zoll-Tonabnehmer mit einem Eigengewicht von
3 - 10 g eingebaut werden.
Lösen Sie dazu die konische Mutter (9) hinter dem Sys-
temträger. Ziehen Sie nun den Systemträger nach vorne
ab (Fig. 7). Entfernen Sie die beiden Befestigungsschrau-
ben und ziehen Sie die Anschlussleitungen am System
vorsichtig mit einer Pinzette ab.
Das neue System zuerst nur leicht anschrauben und die
Anschlussleitungen wieder auf die Anschlussstifte ste-
cken, dabei die Farbkodierung beachten:
R = Rot, rechter Kanal
RG = Grün, rechter Kanal Masse
Fig. 7
L = Weiß, linker Kanal
LG = Blau, linker Kanal Masse
Das Anschlussbeispiel in Fig. 8 gilt für das System AT 95 E!
Schieben Sie den Systemträger in die beiliegende Monta-
gelehre. Die Montage ist korrekt, wenn die Abtastnadel,
von oben betrachtet, in der V-förmigen Aussparung der
Systemeinbaulehre steht. Von der Seite betrachtet, muss
die Nadel im Bereich der rechteckigen Aussparung ste-
hen (Fig. 9).
Stecken Sie den Systemträger wieder auf das Tonarm-
rohr und schrauben die Mutter (9) fest.
ACHTUNG!
Seien Sie bei diesem Vorgang sehr vorsichtig, damit nicht
durch unabsichtliche Bewegung die Abtastnadel beschä-
digt wird.
Nach Beendigung der Systemmontage müssen die Befes-
tigungsschrauben festgezogen werden.
Abtastnadeltausch
Fig. 8
Die Abtastnadel ist durch den Abspielvorgang natürlichem
Verschleiß ausgesetzt. Wir empfehlen daher eine regel-
mäßige Überprüfung der Diamantabtastnadel nach ca.
500 Spielstunden.
Abgenutzte oder beschädigte Abtastnadeln beschädigen
Ihre Schallplatten!
Fig. 9
R = Rot rechter Kanal
RG = Grün rechter Kanal Masse
L = Weiß linker Kanal
LG = Blau linker Kanal Masse
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thorens TD 235 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thorens TD 235 in the language / languages: English, German, French as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info