Manual Thorens TD 235 (page 5 of 15) (English, German, French)

582506

Zoom out

Zoom in

1/15

Unpacking and set - up

Take the record player and all accessories out of the

carton. Remove the two transportation locks (Fig. 1)

by applying lateral pressure. The locks are located

underneath the platter at the front left and at the rear

right.

Put the platter onto the sub-platter and press down

the two safety springs until they set into the groove

of the platter spindle (Fig. 2).

Insert each hinge into the respective recess (Fig. 3).

Hold the dust cover parallel to the hinges (opening

angle approximately 60°), insert and push as far as it

will go. Being in this position the dust cover may be

removed at any time.

Electrical connections

By choosing the appropriate THORENS mains

transformer this record player can be operated from

nearly all existing public mains supplies. The

low-voltage plug on the cable that is coming from the

mains transformer unit is to be inserted into jack 17

(Fig. 4) at the rear side of the record player.

The stereo signal leads have two phono plugs which

are also known as "Cinch" or RCA-plugs. They are

marked with either the letter "L" for the left channel

or "R" for the right channel. lf these letters are

missing then most likely the right channel is marked

red, perhaps by featuring a red plug at both ends,

and the left channel is marked white or black

accordingly. The RCA-plugs are inserted into the

phono input jacks of an amplifier or receiver. The

separate single litz-wire is making a connection to

ground and is to be fastened underneath the ground

screw of the amplifier or receiver.

IMPORTANT!

ALWAYS KEEP THE SHIPPING CARTON IN A

DRY PLACE FOR THE EVENT THAT THE

RECORD PLAYER HAS TO BE PACKED AGAIN

FOR TRANSPORTATION.

IN THIS CASE IT IS IMPORTANT TO DETACH THE

PLATTER AND PUT IT ON THE BOTTOM

OF THE

SHIPPINGBOX, JUST AS IT WAS ORIGINALLY

DELIVERED TO YOU.

Déballage et assemblage

Retirez l'appareil ainsi que toutes les pièces

accessoires du carton d'emballage.

Enlevez les deux butées de transport en les

poussant latéralement (Fig. 1). Elles se trouvent

à l'avant gauche et à l'arrière droit sous le pla-

teau du tourne-disque.

Posez maintenant le plateau sur la plaque sup-

port du moteur et poussez les deux ressorts

d'arrêt vers l'arrière jusqu'à ce qu'ils s'encliquet-

tent dans l'orifice de l'axe du plateau (Fig. 2).

Enfoncez les deux charnières dans les ouvertu-

res prévues à cet effet

(Fig. 3).

Placez le couvercle parallèlement aux charniè-

res (angle d'ouverture env. 60°) jusqu'à ce qu'il

soit bloqué dans celles-ci. Ainsi, le couvercle

peut être enlevé à tout moment.

Branchements

L'utilisation d'un transformateur d'alimentation THO-

RENS correspondant vous permet de connecter le

tourne-disque à toutes les tensions alternatives

existantes. La fiche basse tension du câble trans-

formateur d'alimentation doit être enfoncée dans la

prise 17 (Fig. 4) à l'arrière de l'appareil.

Le cordon de raccordement stéréo possède deux

fiches phono (aussi appelées fiches Cinch ou fiches

RCA par certains fabricants). Elles sont, soit mar-

quées d'un L pour le canal gauche, soit d'un R pour

le canal droit. À défaut de ces lettres, le canal droit

est en rouge et le canal gauche en blanc. Les fi-

ches Cinch doivent être enfoncées dans les prises

phono de l'amplificateur ou du récepteur.

Le cordon livré séparément assure la connexion al

la masse ou à la terre. Veuillez le coincer sous la

borne de masse de l'amplificateur.

IMPORTANT!

CONSERVEZ LE CARTON D'EMBALLAGE AU

CAS OÙ VOUS DEVRIEZ REMBALLER L'APPA-

REIL POUR LE TRANSPORT. DANS CE CAS,

RETIREZ LE PLATEAU DE L’APPAREIL ET DÉ-

POSEZ-LE DANS LE FOND

DU CARTON, DANS

SON EMBALLAGE ORIGINAL.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Thorens TD 235 in the language / languages: English, German, French as an attachment in your email.

The manual is 0,73 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Thorens TD 235 Manual

Product: