582496
24
Zoom out
Zoom in
Previous page
1/56
Next page
Unpacking and Assembly
Carefully remove the unit and its accessories from the
shipping box.
Supplied items:
Attention: The surface of both plinth and platter is
quite sensitive to scratches. It is therefore recom-
mended that you wear the gloves supplied when
assembling the turntable.
1 x plinth (with/without tonearm)
1 x tonearm counterweight
(only with tonearm)
1 x motor in housing
1 x Thorens drive belt
1 x platter with felt mat
1 x electronic control unit PS 800
1 x mains adaptor
1 x power cord
1 x stylus balance
1 x adaptor for single records
3 x protective pads
2 x cotton glove
Proceed by placing the three protective pads where the
turntable is eventually going to be. They are provided
to prevent the sensitive surface of furniture from being
damaged by the turntable’s spiked feet.
Now put the feet of the turntable onto the pads and, af-
ter the final position has been achieved, make sure that
the plinth is level. For any fine-adjustments turn the tip of
each foot up or down until the plinth is in a perfect hori-
zontal position. Use a spirit level to check for accuracy.
The motor housing is now inserted into the designated
recess at the rear left corner. This is done by lifting the
plinth and positioning the motor exactly beneath the re-
cess. Lower the plinth slowly so that the motor housing
enters the recess. Great care should be taken while do-
ing this in order to prevent any scratches on the plinth
surface. When in its final position the motor housing
should not touch the inside of the recess.
24
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thorens TD 2035 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thorens TD 2035 in the language / languages: English, German, French as an attachment in your email.

The manual is 1,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info