Manual Thomson WHP3326 - 131974 (page 5 of 58) (English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Portuguese, Spanish, Finnish)

644916

Zoom out

Zoom in

1/58

5.Technical specications

Transmitting mode UHF stereo

Carrier frequency 863 MHz

Operating voltage

Transmitter: 8 V, 80 mA

Receiver: 2.4 V,

(2 x 1.2 V NiMH AAA)

Frequency range 20 Hz – 20 KHz

Distortion < 2%

Signal-to-noise ratio > 54 dB

Range

100 m max. (outdoors)

20–30 m (indoors)

Operating time 8 hrs (at medium volume)

6. Installing the transmitter/charging station

• Connect the power supply to the power socket on the

rear side of the transmitter.

• Connect the power supply to a mains socket.

• Connect the RCA plugs of the audio adapter cable to the

RCA sockets on the rear side of the transmitter. Connect

the other end (jack plug) to the headphone jack of your

audio source (television, hi- system, DVD player, MP3

player, etc.).

Note

• The green LED indicator on the transmitter lights

up if you have switched on the audio device. The

transmitter will automatically switch off after about 4

minutes if it does not receive an audio signal.

• If, however, an audio signal is detected, the

transmitter will automatically switch on.

7. Installing the receiver/headphones, Fig. 2

• Carefully pull off the earpad on the right-hand side.

•

Insert the two batteries supplied, making sure you

observe correct polarity.

• Reinsert the earpad until it audibly clicks into place.

• Switch off the headphones, and place them in the charg-

ing station for at least 12 hours before using them for the

rst time. The red LED is lit during charging.

8. Getting started

• Turn on the audio source connected to the transmitter (TV

or audio player). The gr

een LED lights up.

• Put the on/off switch of the headphones in the ON

position. The red power indicator lights up.

• The green signal indicator lights up once as soon as the

signal connection between the transmitter and head-

phones has been set up.

• Put the headphones on and set the volume to the desired

level.

Note

• If you cannot get an optimum signal frequency, press

the Tune button on the headphones.

• The Tune button can also be used to improve stereo

reception. In this case, however, you should keep a

distance of 7 m from the transmitter.

• If you cannot get an adequate frequency, change the

frequency channel on the rear side of the transmitter.

Then select the corresponding channel on the

headphones by pressing the Tune button.

The transmitter will automatically switch off if it receives no

audio signal for approximately 4 minutes, or if the signal

from the audio source is too weak for awless reception. As

soon as the signal strength is sucient, the transmitter will

automatically switch back on.

9. Charging, Fig. 3

• Put the on/off switch of the headphones in the OFF

position.

• Place the headphones in the charging station as shown,

and make sure that the charging contacts of both devices

properly touch each other.

• The red LED indicator should be lit. Charging begins

automatically.

Note

• To prevent damage to the batteries, always switch off

the headphones when they are not in use.

• Before using them for the rst time, the batteries

should be fully charged. To guarantee an acceptable

charge, the batteries should initially be charged for 12

hours. Make sure that the headset receiver is switched

off during charging.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Thomson WHP3326 - 131974 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Portuguese, Spanish, Finnish as an attachment in your email.

The manual is 0,61 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Thomson WHP3326 - 131974 Manual

Product: