576911
7
Zoom out
Zoom in
Previous page
1/15
Next page
7
Gas Burners
(1) Ensure gas supply is connected and turned on. (2) Push in the control knob and turn
anticlockwise to full rate – large flame ( ). (3) Continue depressing the knob whilst
holding a lighted match to the burner. (4) After the burner is lit continue depressing the
knob for approximately 10 - 15 seconds. (5) Release knob and turn to required heat
setting. (6) If burner has not lit within 15 seconds, release knob and wait at least 1 minute
before repeating operations (2) to (5). (7) To turn off, rotate the control knob until the line
on the knob is aligned with dot on the control panel.
For models fitted with Spark Ignition the procedure is similar except that the burner is
ignited by depressing the ignition button located on the fascia.
Always make sure the control knob is in the off position when you have finished using the
hotplate burners.
Electric Hotplate (Dual Fuel Models Only)
(1) Ensure the electricity is switched on. (2) The hotplate control is numbered from 1 (Low)
to 6 (High). To turn it on, rotate the knob either clockwise or anti-clockwise to the required
heat setting. (3) To turn the hotplate off, rotate the knob until the line or pointer on the knob
lines up with the zero on the control panel.
The hotplate is a sealed construction and transfers heat through conduction. For maximum
efficiency use the correct size pan with a flat heavy gauge base. The pan size should be
the same or slightly larger than the hotplate (up to 1” / 2.5 cm oversize).
Before using your hotplate for the first time, we recommend that you prime and then
season it.
To prime the hotplate:-
Switch on the hotplate for a short period, without a pan, to harden and burn off the coating.
Use a medium to high setting for 3 – 5 minutes. A non toxic smoke may occur during this
process. Allow it to cool, then season.
To season the hotplate:-
Heat the hotplate for 30 seconds on a medium setting, then switch off. Pour a minimal
amount of unsalted vegetable oil onto a clean dry cloth or paper towel, and apply a thin
coat of oil to the hotplate surface. Wipe off any excess oil, then heat the hotplate on a
medium setting for 1 minute. Occasional seasoning will help to maintain the appearance.
OPERATION
Avoid old or misshapen pans as these may cause instability.
The two in line Hob burners on this appliance will support pans from 10 to
20cm. The single hob burner will support pans from 10 to 22cm.
Using larger pans may reduce performance or cause damage
The lid must be opened fully prior to using the hotplate burners
.
Children should be supervised to ensure they do not play with the
appliance
Glass lids may shatter when heated. Turn off all burners and hotplate and
allow to cool before closing the glass lid.
Remove all spillage from the surface of the glass lid before opening.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thetford S-OH77000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thetford S-OH77000 in the language / languages: English as an attachment in your email.

The manual is 0,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Thetford S-OH77000

Thetford S-OH77000 User Manual - German - 17 pages

Thetford S-OH77000 User Manual - French - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info