576912
6
Zoom out
Zoom in
Previous page
1/7
Next page
6
INSTALLATION
A cut-out should be prepared in the worktop as shown in Fig.2. Heat barriers must be fitted
to the front and back edges of the cut-out as shown in Fig.3 - Section B-B. The appliance
should be fixed in position using woodscrews fitted through the side flanges as shown.
A direct distance of 200mm must exist between the edge of the appliance burners and any
combustible material, unless protected by a layer of non-combutible material. All
combustible materials such as curtains and shelves must be kept well clear of the
appliance. Any fitments such as a cupboard above the unit must have a minimum
clearance of 500mm between the fitment and the top of the Panrest.
In the case of appliances that do not have grills fitted, the underside of the appliance must
be shielded. It is recommended that the shield be fabricated from non-combustible
material, but if the enclosure is manufactured from combustible material, then a minimum
air space of 100mm must exist between the material and the lowest part of the appliance.
Appliances fitted with a grill require that a grill compartment be created below the cut-out
as shown in Fig.4. The compartment must be completely lined with a non-combustible
material such as aluminium or stainless steel. The grill compartment must have ventilation
holes at the compartment floor level and additionally include an escape route to the
outside to prevent the accumulation of unburnt gasses. Any cabinets beneath the grill
compartment must be sealed to prevent the ingress of unburnt gas.
CONNECTION
Gas Connection
The gas connection is made to a 8mm Ø inlet pipe, beneath and to the rear of the
appliance. Prior to connection remove the plastic protection plug from the fitting. It is
recommended that the appliance be connected by copper pipe, rubber tubing MUST NOT
be used.
IMPORTANT
After installation the appliance MUST be tested for soundness
Test ALL burners on high and low flame for flame stability.
The gas supply input pressure MUST not rise or fall significantly from
nominal when ALL appliances connected to the supply are operated
simultaneously. If NOT installed to the manufacturers instructions detailed
herein, we the manufacturer can not be held responsible for any problems
that occur, or poor performance that is perceived/witnessed.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thetford S-656 MK 12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thetford S-656 MK 12 in the language / languages: English as an attachment in your email.

The manual is 0,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info