Manual Thetford N110 (page 7 of 66) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian)

45183

Zoom out

Zoom in

1/66

unavailable, the vehicle engine is running and a voltage higher than 11 V is available.

If a fault occurs during electrical powering (230 V or 12 V), an error message will

not be shown on the display as long as another energy source is available. The

system will automatically switch to the available energy source that has the highest

priority.

6.3.2 Selecting electrical power manually

Mains voltage (230 V):

The LED warns you whenever insufficient voltage is available or if a fault occurs.

If this happens, the LED will start flashing once per second and an error code is

shown in the LCD display.

When sufficient current is available again, or the fault has been resolved, the LED

will emit a steady blue light again.

Direct current (12V):

The LED warns you whenever your vehicle’s engine is not running, or if a fault

occurs, or if insufficient voltage is available. If this happens, the LED will start

flashing once per second and an error code is shown in the LCD display.

Once the engine is running, or the fault has been resolved, or sufficient voltage is

available again, the LED will again emit a steady blue light.

NB: If the refrigerator has been manually set to operate at 12 V, it will not

automatically switch to another energy source when your vehicle’s engine is not

running. In this case, the refrigerator will stop cooling.

6.4 Powering with gas

Powering with gas can be selected both by the Auto mode (only Automatic fridges)

and manually.

Warning! - Flammable material must be kept away from the rear of the refrigerator.

- For selection of gas type, see the information plate inside your refrigerator.

- For the pressure regulator model, see the information plate inside your

refrigerator and the table at the back of this booklet.

- The type of gas container and its location must be in compliance with the most

recent regulations. Ensure that the unit is installed in a location with good

ventilation and make sure that the ventilation openings in the gas container

storage location remain open.

- The changing of the gas container must be done outside in the open air and out

of reach of any possible sources of ignition.

- It is prohibited to use gas to power the refrigerator while you are driving.

- It is prohibited to use gas to power the refrigerator in the vicinity of petrol

stations.

6.4.1 Auto mode

The system will select gas operation if:

- mains voltage (230 V) is unavailable;

- the vehicle’s engine is not running.

Once mains voltage (230 V) is available again or the vehicle’s engine is running, the

system will switch to the available energy source that has the highest priority if the

fridge is in Auto mode.

If the refrigerator switches from 12 V DC to gas operation when it is in auto mode,

the system will wait for about 15 minutes before igniting the gas. During this time,

however, the gas indicator lamp will come on. The delay is built in to avoid it

switching to gas operation whenever you stop to refuel your vehicle. You can cancel

the delay by immediately switching the refrigerator off and then on again.

If the system selects gas operation, the ignition will be activated automatically. The

gas will flow to the burner and be lit by the electric ignition. If the flame goes out,

the gas will immediately be lit again.

6.4.2 Selecting gas operation manually

If the flame cannot be lit within 30 seconds, the gas supply will stop and gas

mode will be switched off. The LED start flashing every second and an error

code is shown in the LCD display.

The gas mode can be reset only if the refrigerator is switched off. If you switch the

refrigerator on again and the gas mode is still not working, the LED of the manual

gas mode will flash to indicate that gas is unavailable and an error code is shown in

the LCD display.

Important! It is prohibited to use gas to power the refrigerator while you are

driving. If a road accident results in a fire, there is a danger of explosion. It is

prohibited to use gas to power the refrigerator in the vicinity of petrol stations. If it

takes longer than 15 minutes to refuel your vehicle, you should switch the

refrigerator off using the main switch (A).

6.5 Switching off the refrigerator

- Push the main switch (A).

- The blue LED will go out.

- The refrigerator is now completely switched off.

- Use the special storage latch on the door locking mechanism to fixate the open

door. This prevents unpleasant odours and mould in the refrigerator.

7 MAINTENANCE

Regular maintenance is necessary to ensure the correct functioning of your

refrigerator.

7.1 Cleaning

Tip! A good time to clean your refrigerator is straight after you have defrosted it.

- Clean the refrigerator with a soft cloth and mild detergent.

- Dust the refrigerator with a soft, moistened cloth.

- Use a brush or soft cloth to remove once a year any dust from the condenser at

the inside of the refrigerator.

Important! - Do not use soap or aggressive detergents that are abrasive or

soda-based.

- The removable interior components of the refrigerator are not dishwasher proof.

7.2 Defrosting

Frost will gradually build up on the condenser of the refrigerator. You should defrost

the refrigerator as soon as the frost layer is about 3 mm thick. Frost reduces the

refrigerating capacity and life of your refrigerator.

- Remove the ice cube tray and all food.

- Switch off the refrigerator.

- Leave the refrigerator door open.

- Place dry towels in the refrigerator to absorb the water.

- Place trays containing hot water in the freezer compartment.

- After defrosting (when the freezer compartment and condenser are frost-free),

remove the towels and the water trays and use a cloth to dry off the refrigerator.

- Switch the refrigerator on again in the way described in section 4.1 (“Igniting

and starting your refrigerator”).

Important! - Do not use force or sharp objects to remove frost.

- Do not try to accelerate defrosting by using (for example) a hairdryer.

7.3 Door locking mechanism

Frost will form in the refrigerator if the door is not closed properly. To determine

whether the door closes properly, close the door with a piece of paper between the

door and the refrigerator. Pull at the piece of paper. If you feel resistance, the

refrigerator door closes properly. If you feel no resistance, the door does not close

properly. Perform this test regularly on all four sides of the refrigerator door.

If you find that the door does not close properly, check whether the door locking

mechanism keeps the door properly shut.

7.4 Winter operation

If you use the refrigerator when the outdoor temperature is below 8°C, install the

Thetford vent winter/storage cover (see illustration 10) on the ventilation grills. The

cover protects your refrigerator from excessively cold air. The winter cover is a

refrigerator accessory obtainable from your caravan dealer.

Tip! It is advisable to use the winter/storage cover if you are not going to use the

vehicle for a long period of time.

IMPORTANT; DO NOT USE THE WINTER/STORAGE COVER IN TEMPERATURES

GREATER THAN 8°C AS THIS CAN DAMAGE THE COOLING UNIT AT THE REAR OF

THE FRIDGE. Remove the covers & re-fit when placing the vehicle back into

storage.

7.5 Maintenance of gas equipment

A qualified service engineer must maintain and inspect gas and electrical

equipment. It is advisable to have this maintenance work performed by a customer

service centre. Contact the Customer Service department of Thetford for a list of

qualified parties.

Important! European laws covering gas appliances and extractors prescribe

observance of the following rules (which are the user’s responsibility):

- appliances that run on liquid gas must be inspected before being used for the

first time and every year thereafter.

- the gas burner must be cleaned at least once a year or more frequently if

necessary.

- If a gas hose is used, it must be checked annually. This hose has a limited life

and, thus, must be regularly replaced. Check the hose regularly for cracks, splits

and ageing. If in doubt, replace the hose. Pay attention to the maximum life of

the hose and replace it in time, as advised by the manufacturer or in

conformance with local regulations.

- For replacement, a gas hose approved in accordance with the local regulations

must be used . Position the hose so that it can rotate, is not kinked, and will

allow no bends to occur.

- Due to the limited life of the gas hose, it must be installed so that replacement is

possible.

7.6 Maintenance checklist

This refrigerator will give you many years of trouble-free use if you simply run

through the following checklist regularly:

- keep the refrigerator clean (see section 7.1, “Cleaning”);

- defrost the refrigerator as often as is necessary (see section 7.2, “Defrosting”);

- check the door closing mechanism regularly (see section 7.3, “Door locking

mechanism”);

- make sure that the ventilation grills are not blocked;

- Regularly clean the ventilation grills.

- 9 -

6071_BW.qxd 24-06-2005 14:58 Pagina 9

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Thetford N110 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian as an attachment in your email.

The manual is 2,68 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Thetford N110 Manual

Product: