641132
10
Zoom out
Zoom in
Previous page
1/46
Next page
Owner’s Manual 10
Automatic mode operation:
When the refrigerator is in AUTO mode, the electronic controls of the refrigerator automatically select and use the most efcient energy
source that is available for operation.
During operation, if a more efcient energy source becomes available, the electronic controls of the refrigerator automatically changes
from the current energy source to the more efcient energy source as follows:
- The rst choice of operation is AC electric mode.
- If AC electric is not available to the refrigerator, if the AC electric is outside of the permitted operating range, or if the AC heater
does not operate; the electronic controls of the refrigerator automatically change to the second choice of operation.
- The second choice of operation is gas mode.
- The refrigerator attempts to operate the propane gas burner. If unable to establish and maintain a ame, a “no” FL” fault code
shows on the LCD. Refer to “Fault Codes” section of this manual.
Removing air from the propane gas supply lines:
For safety reasons, the burner is made to ignite on propane gas within a specied amount of time. When starting the refrigerator for the
rst time, after storage, or after replacing the propane gas tank, the propane gas supply lines can have air in them. Due to the air in the
gas supply lines, the refrigerator may not ignite on propane gas within the specied amount of time.
To remove the air from the propane gas supply lines:
- Make sure that all of the gas valves are open.
- Push and release the POWER ON/OFF button [30] to turn on the refrigerator.
- Push and hold the MODE button [31] until the Manual mode gas indicator [284] is on.
- Push and release the TEMPERATURE SET button until the desired temperature setting shows.
- The refrigerator will start a 30 second trial for ignition.
- During the 30 second trial for ignition, the refrigerator controls open the gas safety valve and the igniter sparks.
- After 30 seconds, if the Manual mode gas indicator remains on, it means that the refrigerator is operating on propane gas.
- At this time, all of the air is removed from the propane gas supply lines and you may select AUTO mode of operation if
you wish.
- If the gas does not ignite within 30 seconds, the gas valve of the refrigerator will automatically close and a “no” “FL” fault code
will show in the LCD. To reset the controls, press and hold the POWER ON/OFF button for 1 second to turn the refrigerator
off, then press it again to restart the refrigerator and begin another 30 second trial for ignition.
- Depending on how much air may be in the propane gas supply lines, you may need to repeat the 30 second trial for
ignition two or three times.
- If the burner does not ignite on propane gas after two or three attempts, stop and consult your local dealer or an
authorized Norcold Service Center.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thetford 2118 PolarMax at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thetford 2118 PolarMax in the language / languages: English as an attachment in your email.

The manual is 6,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Thetford 2118 PolarMax

Thetford 2118 PolarMax Additional guide - English - 18 pages

Thetford 2118 PolarMax Installation Guide - English - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info