648192
26
Zoom out
Zoom in
Previous page
1/32
Next page
USING THE PANEL HEATER
1) Description of the control unit : r
u Mode switch knob.
v ECO temperature set value adjustment knob.
w COMFORT temperature set value adjustment knob.
V1 Heating light.
V2 ECO mode light.
V3 COMFORT light.
2) Fixing the comfort temperature :
The comfort temperature that you would like while the room is occupied.
a) Set the cursor u to
, the heating light V3 comes on.
b) Set the control knob w to 5, the heating light V1 comes on, if the room temperature is below the required temperature.
c) Wait a few hours until the temperature stabilizes.
d) If the setting is satisfactory (if necessary use a thermometer to check), mark the position.
If the setting is not satisfactory, adjust it and start again from point c.
3) Fixing the Eco temperature :
This is the required temperature during periods when the room is unoccupied.
It is recommended that this mode should be used if the room is unoccupied for more than 2 hours.
a) Set the cursor u switch knob to
, the heating light V2 comes on.
b) Adjust the control knob v between 3 and 4, the heating light V1 comes on, if the ambient temperature is lower than
the instruction of desired Eco temperature.
c) Wait a few hours until the temperature stabilizes.
d) If the setting is satisfactory (if necessary use a thermometer to check), mark the position.
If the setting is not satisfactory, adjust it and start again from point c.
4) Frost-Free mode :
This mode is used to keep the temperature at approximately 7°C in the room when you are absent from the house for
a prolonged period (i.e. more than 24 hours).
a) Set the cursor u to
.
5) The heating indicator : V1
This light indicates periods during which the element is heating. It flashes when the temperature is stable, and it goes
off if the temperature is too high.
6) Switching off the device :
To set the device to the Off position, move the cursor to .
7) Locking the controls : s
It is possible to lock or limit the range of use of thumb-wheels v and w and lock selector switch cursor u to prevent
the inadvertent manipulation of the device (by children, etc).
a) Detach the device from its wall bracket.
b) On the back of the thermostat box, detach pins P from their supports.
c) Choose position B to lock the thumb-wheels or position L to limit the range of use of the thumb-wheels.
Choose one of the positions M to lock the person in the desired mode.
sdnammoC
devieceR
tnerrucoN
onnoitanretlA
)''75'4(tnerruc
)''3(V032esahp
onnoitanretlA
)''35'4(tnerruc
)''7(V032esahp
etelpmoC
V032noitanretla
-flahevitageN
V511-noitanretla
-flahevitisoP
V511+noitanretla
epocsollicsO
lartueN/féR
edoM
deniatbo
trofmoCC°1-trofmoCC°2-trofmoCocEezeerf-itnApotStuCrewoP
Table of commands the panel heater can receive on its pilot wire. To be measured between the pilot wire and the neutral.
080214_CEETvariation_ang.PMD 07/09/05, 14:062
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermor TH5271410 - 100 VAPB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermor TH5271410 - 100 VAPB in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 2,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info