771201

Thermor FLAT MP 80 Manual

11
Zoom out
Zoom in
Previous page
1/62
Next page
3/
SHOWER READY
(Ref. C): Monitoring indicator of hot water available. When the shower symbol
60
is turned on, volume of hot water is equal or higher than 1 shower need.
61
2.
SQUARE RANGE
62
1/ SETTING KNOB (Ref A and D): Manual selection of temperature setpoint. Position of ref. C is the
63
maximum position of temperature setting.
64
2/
FROST FREE
Mode
(Ref. B): Automatic regulation at frost-free temperature (7°C), in order to reduce
65
the electric consumption during the periods of absence of the user.
66
3/
HEATING LIGHT INDICATOR
(Ref. D): When the heating element symbol is turned on, the water is
67
being heated.
68
69
70
71
72
When a malfunction occurs, the user interface of the appliance can display an error code.
73
1.
FLAT RANGE
74
Fault (LED status)
Meaning
Remark
2 successive «shower» blinking, 3 secs of
pause, 2 successive shower blinking…
Error 3:
Probe fault
Change probe
2 successive «shower» blinking, 3 secs of
pause, 4 successive shower blinking
Error 9:
Relay or PCB fault
Change PCB
75
CAUTION: Before removing the plastic cover, make sure the power is turned off to avoid any risk of injury
76
or electric shock.
77
1.
USER MAINTENANCE
78
Operates once a month the discharge of the safety valve to prevent scaling deposit and verify that
79
the safety device is not blocked. If this is not done, damage may be caused and the guarantee invalidated.
80
For an installation with a booster pump; before starting up, after a long period of disuse, turn the rotor fol-
81
lowing the advice in the manufacturer’s instructions.
82
2.
MAINTENANCE BY A QUALIFIED PERSON
83
-
Scaling: Remove the scale sludge. Do not scrape or hammer the lime scale deposited on the casing,
84
as this may damage the lining.
85
-
Magnesium anode: change the magnesium anode every 2 years or when its diameter is lower than 10 mm.
86
-
Heating element: the replacement of a sheathed heating element involves draining of the water
87
heater and replacement of the flange gasket. Reassemble the heating element, reasonably tight nuts
88
(cross tightening), check that there is no leakage after the first heating-up, tighten again if necessary
89
-
Drain: Turn off power and cold-water supply. Open hot water taps and drain valve of the safety device.
90
Spare parts list: thermostat, flange gasket, heating element, heating light indicator, magnesium anode,
91
connection wires, electric switch. The guarantee requires genuine manufacturer’s parts to be used.
92
Advice to the user
93
94
95
96
EN
TROUBLESHOOTING
MAINTENANCE
11
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermor FLAT MP 80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermor FLAT MP 80 in the language / languages: English, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 2.61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info