648194

Thermor Equateur 2 Manual

93
Zoom out
Zoom in
Previous page
1/94
Next page
User’s manual User’s manual
GB
91
Problem encountered Check to be made
The radiator does not
heat enough
Increase the Comfort set temperature.
If the setting is at the maximum, make the following checks:
-Check if there is another heating source in the room
- Make sure that your radiator is only heating the room (door
closed).
- Have the radiator power supply voltage checked.
- Check if the power of your radiator is appropriate for the
size of your room (we recommend about 100W/m
2
for a
ceiling height of 2.50 m).
Traces of dirt collect
on the wall around the
radiator
Dirt is caused by poor quality of ambient air. In this case, it
is recommended that good aeration of the room (ventilation,
air inlet, etc.), and cleanliness of the air should be checked,
and do not smoke indoors. This dirt does not justify
replacement of the radiator under guarantee.
The heating pictogram
is displayed on the
screen when the
radiator is in ECO mode
This operation is normal. The radiator can warm up so as to
maintain an Eco temperature.
For radiators equipped with a programming system or controlled through the pilot wire.
The radiator does
not follow external
programming controls
Make sure that the programming control unit is used
correctly (see user’s instructions), that the programming unit
is properly engaged in its housing and that it is functioning
normally (check the condition of the batteries, fuse, etc. ).
Make sure that your radiator is in Program mode and that
the external « centralised » program is assigned to the
required day of the week.
The radiator surface is
very hot
It is normal that the radiator should be hot when it is in
operation, but the maximum surface temperature is limited
in accordance with the NF Electricity performance standard.
However, if you think that your radiator is still too hot, make
sure that the power is appropriate for the surface area of
your room (we recommend 100W / m² for a ceiling height
of 2.50 m) and that the radiator is not placed in a draft that
would disturb its regulation.
There is a signicant
difference between the
ambient temperature
in the room and
the equipment set
temperature
After 6h stabilisation, you can recalibrate your radiator by
doing a long press (3 sec) on
and and wait until «
OFFSET » is displayed.
Set the observed temperature difference by pressing the +
or - button and then conrm by pressing the
button.
Example: If the ambient temperature is 20°C and the set
temperature is 18°C, add +2° to the «OFFSET » value.
16 - APPENDIX
16.1 - Warning
- Do not cover the radiator, to avoid overheating and for security reasons .
- Make sure that children are not leaning on the radiator surface and are not playing nearby
when it is in operation, since under some circumstances the surface of the radiator could
cause skin burns, particularly because their reexes are not fully developed or they are
slower than for adults. If there is any risk, install a protection grill in front of the radiator.
- This radiator is not designed for use by persons (including children) whose physical,
sensorial or mental capabilities are limited, or persons without any experience or knowledge,
unless they are supervised or given prior instructions about use of the equipment by a
person responsible for their safety.
- Children should be monitored to make sure that they do not play with the radiator.
- Make sure that you do not insert objects or paper into the radiator.
- Whenever doing any work on the radiator, the radiator itself and the external power
manager (if there is one) should be switched off.
16.2 - Identification of the radiator
Before calling our Before and After Sales Department, remember to identify the radiator
references. This informations are written on the name plate located on the right side of the
radiator.
A Standards, quality labels
B Trade name
C Commercial code
D Manufacturing reference
E Serial number
F Manufacturer’s number
Equateur2_1880-1585_interieur.indd 91 18/06/12 06:23
… 93


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermor Equateur 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermor Equateur 2 in the language / languages: English, French as an attachment in your email.

The manual is 6,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info