600937
6
Zoom out
Zoom in
Previous page
1/37
Next page
6
control enables the boiler to operate in a low tariff rate and thus significantly reduce energy costs. Maximum boiler output
can be limited in the service menu if the operation must proceed also outside the so-called low tariff.
!!! Shall other ways of installing the MRC receiver be applied the output of which is one of the phases (MRC/L1
-L3), it is necessary to assure transmission to the R level (reset conductor) by means of e.g. installing an
auxiliary relay in the external distributor.
Soft start
The soft start function rests in a gradual heat-up of the heating system which is therefore protected against abrupt upward
temperature gradient. When the boiler is switched on or a new regulation period is initiated and the resulting quick change
in temperature caused by induction of heat into the system could also bring about noise due to the dilatation of pipes, the
boiler is actuated in the so-calledsoft startand limits the output after it is launched.
Auto-diagnostics, unambiguous signalling and service messages
THERM-EL electric boilers are equipped with a very useful system of auto-diagnostics chiefly with respect to service.
This function facilitates speedy and efficient removal of a potential boiler defect. Apart from the commonly displayed user
values heating water temperature (the TOP circuit), DHW temperature, outdoor or room temperature sensor, TOP circuit
pressure the display can show other service information if the service menu is set up correspondingly: E.g. disconnection
or short circuit of all sensors, boiler output, MRC condition and other error messages.
Wide choice of parameter settings
Service and user menus of THERM-EL boilers provide a wide range of boiler settings according to specific conditions of
operation or based on customer requirements:
- The option of setting various outputs for the heating water and heating of DHW undoubtedly offers positive financial
effects.
- The possibility of setting different outputs with the MRC signal switched on or off provides the user with a pleasant heat
comfort.
External energy input control
If there are several concurrently operating electrical apparatuses and the household has increased requirements for power
take-off, the THERM-EL boiler user will certainly appreciate the external energy input control function. A relief relay can
be connected to the distributor with a pre-set value of the electric current. If the current reaches e.g. 30 A, the boiler
disconnects a specified number of heating bars and relieves the whole system.
SLEEP standby mode
Another function the advantage of which will be namely appreciated by those users who stay outside home for longer
periods of time is the SLEEP mode. This mode is used in situations when the house will not be inhabited for an extended
period and the user wants to have the heating system reliably safeguarded against solidification or freeze-up. Boiler in the
SLEEP mode consumes minimum amount of power but the protective boiler functions spinning, unblocking and anti-
freeze protections are also active. If the boiler is connected to an equitherm sensor, the drop in outside temperature
activates an anti-freeze protection which can protect not only the actual boiler but the entire heating system.
If during the boiler's operation (i.e. not only in the SLEEP mode) none of the control panel buttons becomes
activated (when heating and DHW heating are switched off by the respective button), the display automatically
switches over to the saving mode (only the LED is turned on).
6


Need help? Post your question in this forum.

Forumrules
1

Forum

thermona-therm-el-15

Reset search

  • I Have an EL15 and cannot see how to connect a 3 way motorised valve. Manual shows position on diagram but how is connection physically made? Please help Submitted on 28-9-2022 at 18:47

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermona THERM EL 15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermona THERM EL 15 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info