793582
27
Zoom out
Zoom in
Previous page
1/32
Next page
27
DE GB
Care
The enclosure can simply be cleaned with a damp cloth. Do not use aggressive
cleaners or cleaner’s with a scouring effect!
Legionella prevention
Do not use heated water as drinking water.
After prolonged shutdown of the device for example due holiday, the device
should be fully heated up to the maximum temperature (tap at minimum flow)
before re-using. It is recommended to flush the pipes for one minute.
5. Troubleshooting
First aid
• Check the leakage protection switch and the fuses.
• Check if any fittings or shower head are affected by the build-up of lime scale
or dirt.
• See also „Troubleshooting by users“.
Troubleshooting by users
Problem Cause Solution
Water heater is not heating
at all (water is flowing but the
unit is not heating - the outgo-
ing water temperature is the
same as the cold water supply)
- the digital display does NOT
light up.
No power or incorrect
wiring.
Make sure the breakers at
main electrical panel are
ON. You may have a faulty
breaker or unit may be
wired incorrectly.
Water heater is not heating
at all (water is flowing but
the unit is not heating - the
outgoing water temperature
is the same as the cold-water
supply) The digital display
DOES light up, but no temper-
ature display.
Flow rate is too low /
water pressure is too
low.
Your water heater has an
activation flow rate of ap-
proximately 2.5L/min. If your
water flow rate is less than
this level, your unit will not
activate. Increase the flow
rate or check the filter mat
inside the inlet connector.
The air bubbles in the
water heater have not
been purged out.
Make sure the breakers at
main electrical panel are
ON, turn on the unit and
open the hot water tap for
about 20s.
Flow rate is too low Something was blocked
in the filter mat / Pipe
was blocked
Check and clean the filter
mat inside the inlet connec-
tor.
Water heater is not heating
at all. The LCD display shows
“E2” Internal part failure Please call for your local
service.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermoflow Elex 3in1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermoflow Elex 3in1 in the language / languages: English, German as an attachment in your email.

The manual is 3.86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info