607233
21
Zoom out
Zoom in
Previous page
1/36
Next page
Pag.21
Operation using control knobs. (See pages 17 and 22)
Three buttons are required for operation: - “UP” button – “DOWN” button – “RESET” button To start the system,
press the “UP” en “DOWN” buttons together for at least three seconds. The start-up process is indicated by a se-
ries of three short tones. After the flame has lit, it can be increased to the maximum height by pressing the “UP”
button. Pressing the “DOWN” button reduces the flame size to its minimum height. Pressing the “UP” and
“DOWN” buttons again for at least three seconds switches off the unit. In the event of a fault in the unit, the sys-
tem can be unlocked by pressing the “RESET” button and reset to the “STAND BY” state.
10.4 Gas connection
Mount the gas regulation combination in an accessible place near to the gas block fire (take account of the length
of the connection cables). Use a 1/2“ gas tap with a connector. Fit a (ø12mm) gas pipe between the gas regulation
combination and the Topper-
Pilot flame cover
burner. For model 9013 burner (B / P), mount the flexible gas pipe using
the accompanying radiator connection and nosepiece by first exchanging the flare fitting
for the accompanying nosepiece. Connect the pilot pipe and the ignition cable to the Oxy
stop pilot flame. Also ensure that the gas pipe is free from dirt or sand. You should ensure
that the various connection points are accessible. Ensure that the control equipment does
not become twisted during installation and that there is no excessive tension during con-
nection. After installation, check that the connections are gas tight. Position the pilot
flame cover as shown after the pilot flame burner has been assembled. The pilot flame
cover is not used on the 4525 and 9013 models.
Waakvlamkap
COMBINATION DIAGRAM
Dungs / Exhausto EFC 21
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermocet Transparente 140 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermocet Transparente 140 in the language / languages: English as an attachment in your email.

The manual is 1,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Thermocet Transparente 140

Thermocet Transparente 140 Usermanual and installation guide - Dutch - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info