607254
11
Zoom out
Zoom in
Previous page
1/26
Next page
Page 11
AT I2H, I3B/P BE I2E+ , I3+ DK I2H, I3B/P DE I2ELL, I3B/P
FI I2H, I3B/P FR I2E+, I3+ GR I2H, I3B/P GB I2H, I3+
IS I3B/P IE I2H, I3+ IT I2H, I3+ LU I2E, I3B/P
NL I2L, I3B/P NO I3B/P PT I2H, I3+ ES I2H, I3+
SE I2H, I3B/P CY I3B/P,I3+ EE I3B/P,I2H LT I3B/P,I2H
LV I3B/P,I2H MT I3B/P, HU I3B/P,I2H PL I3B/P
SI I3B/P,I2H SK I2H
10. Technical data GV60 (see also Page 18 and 19)
Model : Classic Fire High / Low
Gas block type : Mertik GV60
Ignition : Distance operation and Piezo ignition
Gas connection : 3/8 “ (Internal)
Unit category : C11-C31 / B11-BS
Pilot : SIT 3 Flams
Combustion gas discharge
and Combustion air supply : Concentric: Ø 100/150 mm
11. Technical data BM 733
Model : Classic Fire High / Low
Gas block type : BM733
Ignition : Manual operation (with one hand) and piezo ignition
Gas connection : 3/8”(Internal)
Unit category : C11-C31 / B11-BS
Pilot : SIT 3 Flams
Combustion gas discharge
and Combustion air supply : Ø100 mm
12. Concentric flue system CC
The balanced flue system consists of a 100 mm Ø inner flue concentric with a 150 mm Ø outer flue. These flues
have been set up concentrically; the combustion gases are exhausted through the internal flue while the fresh
combustion air is supplied between the internal and external flues. Different connections are possible using the
concentric flue system. These are:
Through the roof face and through the exterior wall
The layout used for this system can be laid in different ways,
but there are a few important conditions:
* A minimum of 1 metre of vertical flue must be fitted on the apparatus before a horizontal move is made.
* The total vertical flue length allowed may not exceed 12 metres (the sum of the flue length and the
calculation lengths for the bends).
* The horizontal duct length at the roof outlet should not exceed 5 metres measured between bends.
* 90° bends have a 2-metre horizontal calculation length.
* 45° bends have a 1-metre horizontal calculation length.
* The outlet can be installed at any point on the roof face or exterior wall (supply and discharge with an
identical pressure area), but must meet applicable regulations.
The concentric flue system consists of the following components: (See page 24)
A. Concentric pipe 250/500/1000 mm I. Clamping strap
B. Bend 45° . J. Centring plates (set)
C. Wall bracket K. Roofing sheet, flat, aluminium
D. Not applicable L. Storm collar
E. Bend 90° M. Wall pass-through
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermocet Beverly S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermocet Beverly S in the language / languages: English as an attachment in your email.

The manual is 3,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info