459831
14
Zoom out
Zoom in
Previous page
1/20
Next page
14
Lors du montage et du démontage du thermostat à
horloge, veillez à ce que les fils de raccordement soient
hors tension.
Montage:
L’appareil doit etre monté sur une surface plane et non conductrice.
1. Basculez le couvercle vers le bas
2. Avec un tournevis, orientez la fermeture 8 en position
3. Enlevez le socle gris de la partie thermostat
4. Faites passer les fils de raccordement par les ouvertures du socle
le thermostat ne peut, en aucun cas, être monté sur un support
électriquement conducteur
5. Fixez l’appareil sur le mur, à 1,5 m de hauteur, si possible, sur un
mur intérieur, à un endroit où l’air peut circuler librement
6. Raccordez le socle selon le schéma de raccordement approprié
7. Mettez les câbles à plat dans le socle
8. Adaptez le thermostat à horloge sur le socle câblé
9. Avec un tournevis, orientez la fermeture 8 en position
Attention: veillez à ce que les fentes d’aération 5 dans le socle ne soient pas
bouchées par de la peinture, du papier peint, du plafonnage, etc.
Ensure that when installing and dismantling the clock
thermostat that the voltage in the connecting lead is
switched off.
Mounting: Do not mount the device on an even conductive base.
1. Lower the front cover
2. With a screwdriver turn the seal 8 to position
3. Lift the grey plinth from the control section
4. Pull the connecting wires through the plinth
5. Fix the plinth to the wall approx. 1.5M above the floor, if possible
on an internal wall, against which air can circulate without
hindrance
6. Connect the plinth in accordance with the applicable circuit
diagram
7. Press the connecting leads flat into the plinth
8. Fit the clock thermostat to the wired plinth
9. Turn the seal 8 into position with a screwdriver
Note: Keep the ventilation apertures 5 in the plinth free, no paint, wallpaper
or other such material.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Theben RAMSES 725 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Theben RAMSES 725 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Theben RAMSES 725

Theben RAMSES 725 User Manual - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info