606550
67
Zoom out
Zoom in
Previous page
1/71
Next page
Continuous valve actuator CHEOPS control
theben
As of: Jul-11 (Subject to change without notice) Page 67 of 71
6.3 Checking end position
The end positions stored during the adaption process can be read out in exactly the same way
as the error numbers using the ETS software.
The internal stop position (spindle inserted, valve open) is stored in Hex-format under the
address $1FC and the external stop position under $1FD.
After downloading the application, these values are reset (i.e. $1FC = 00 and $1FD = FF).
The found stop positions are stored here following successful adaption.
If both addresses show 00 after adaption, the adaption is deemed to have been unsuccessful.
To determine the stop positions in millimetres, the values are converted into decimal and
divided by 20.
Example calculation:
Table 31
Position
Valve
Addres
s
Hexadecimal
Value
Equivalent
to decimal
value
Result
decimal value/20 =
Internal stop
Open
$1FC
24
36
1,8 mm
External stop
Close
d
$1FD
61
97
4,85 mm
The stroke is calculated from the two values as follows:
Stroke = external stop - internal stop
In our example:
Stroke = 4.85 – 1.8 mm = 3.05 mm
Limit values for successful adaption
The following values must be respected:
Table 32
Internal stop
External stop
Stroke
Dimension
Hex value
Dimension
Hex value
Dimension
Hex value
0,3mm
6
7,5mm
96
1.2mm
18
67


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Theben CHEOPS control KNX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Theben CHEOPS control KNX in the language / languages: English as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Theben CHEOPS control KNX

Theben CHEOPS control KNX User Manual - English - 1 pages

Theben CHEOPS control KNX User Manual - German - 72 pages

Theben CHEOPS control KNX User Manual - German - 1 pages

Theben CHEOPS control KNX User Manual - Dutch - 76 pages

Theben CHEOPS control KNX User Manual - French - 74 pages

Theben CHEOPS control KNX User Manual - French - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info