2120
SUN - Wireless weather station
SUN - Wireless weather station
•
The indoor temperature will be displayed on the basic station and the basic station
will scan the outdoor temperature and the reception symbol will be flashing.
•
If the reception of the outdoor temperature fails, “- -” appears on the display.
Check if there is any source of interference. After the reception of the radio-con-
trolled time you can start the initialization for the outdoor transmitter manually.
Press and hold
▼
button for 3 seconds. The basic station will scan the outdoor tem-
perature.
4.1. Radio-controlled time reception
•
The clock will now scan the DCF frequency signal and the DCF symbol will be flash-
ing. When the time code is received successfully after 3-7 minutes, the radio-con-
trolled time and the DCF symbol are displayed steadily in the display. During the
DCF time reception period, no outdoor temperature will be transmitted.
•
If there is no reception possible, manual initialization can be helpful.
•
Press the WAVE button.
•
The DCF symbol will be flashing.
•
Interrupt the reception by pressing the WAVE button again. The DCF symbol disap-
pears.
•
The DCF reception always take place at 1:00 o'clock in the morning until 5.00
o'clock. If the reception is not successfully received at 5:00 o'clock, further attempts
will be made again at 1:00 clock in the morning.
•
If the clock cannot detect the DCF-signal (for example due to disturbances, trans-
mitting distance, etc.), the time can be set manually. The DCF symbol disappears
and the clock will then work as a normal quartz clock. (see: Manual setting of the
clock and calendar).
4.1.1 Note for radio-controlled time DCF
The time base for the radio-controlled time is a caesium atomic clock operated by the
Physikalisch Technische Bundesanstalt Braunschweig. It has a time deviation of less
than one second in one million years. The time is coded and transmitted from Main-
flingen near Frankfurt via frequency signal DCF-77 (77.5 kHz) and has a transmitting
Buttons front (Fig. 1)
B1: Light and snooze button
Buttons back (Fig. 2)
B2: MODE button
B3: ALARM button
B4: ▲ button
B5: ▼ button
B6: WAVE button
B7: LIGHT/SNZ button
Housing (Fig. 2)
C1: Wall mounting hole
C2: Battery compartment
C3: Connecting power supply
C4: Stand (fold out)
4. Getting started
•
Place the basic station and the outdoor transmitter on a desk with a distance of
approximately 1.5 meter. Avoid getting close to possible interference sources (Elec-
tronic devices and radio installations).
•
Open the battery compartment of the outdoor transmitter.
•
Insert two new batteries 1,5 V AAA into the battery compartment of the outdoor
transmitter. Make sure the polarities are correct.
•
Remove the protecting foil from the display of the basic station.
•
Connect the basic station to the attached power adapter. Insert the adapter into
the jack at the basic station and connect the power adapter to a wall socket. Impor-
tant! Make sure that your household voltage is 230V! Otherwise your device may
be damaged.
•
The device will alert you with a beep and all LCD segments will be displayed for a
short moment.
•
The backlight is activated permanently.
TFA_No. 35.1133_Anleitung 06.12.2014 14:15 Uhr Seite 11
