504450
10
Zoom out
Zoom in
Previous page
1/34
Next page
MODUS PLUS – Wireless weather station
1918
MODUS PLUS – Wireless weather station
There are 3 different reception symbols:
- reception is active
- reception is very good
- No DCF reception
To activate the DCF reception, press the ALARM button for 2 seconds. The
reception signal - symbol flashes. Press the ALARM button again to stop
scanning DCF time signal.
If the clock cannot detect the DCF-signal (for example due to disturbances,
transmitting distance, etc.), the clock can be set manually.
The clock will then work as a normal quartz clock. (see: Manual setting of
the clock, calendar and day-of-week language).
Note for radio-controlled time DCF:
The time base for the radio-controlled time is a caesium atomic clock operat-
ed by the Physikalisch Technische Bundesanstalt Braunschweig. It has a time
deviation of less than one second in one million years. The time is coded and
transmitted from Mainflingen near Frankfurt via frequency signal DCF-77
(77.5 kHz) and has a transmitting range of approximately 1,500 km. Your
radio controlled clock receives this signal, converts it to shows the precise
time. Changeover from summer time or winter time are automatic. The quali-
ty of the reception depends mainly on the geographic location. Normally
there should be no reception problems within a 1,500 km radius around
Frankfurt.
Please take note of the following:
Recommended distance to any interfering sources like computer moni-
tors or TV sets is at least 1.5 - 2 metres.
Inside ferro-concrete rooms (basements, superstructures), the received
signal is naturally weakened. In extreme cases, please place the unit close
to a window to improve the reception.
During nighttime, the atmospheric interference is usually less severe and
reception is possible in most cases. A single daily reception is adequate to
keep the accuracy deviation below 1 second.
7. Operation
During the reception of the outdoor values or the time is a button opera-
tion not possible.
In the setting mode, press /UNIT or /CH button to select the values.
Press and hold the buttons for fast running.
The instrument will automatically quit the setting mode if no button is
pressed within 10 seconds.
Each button operation is acknowledged with a beep.
7.1 Manual setting of the clock, calendar and day-of-week language
Press the MODE/ENTER button for 2 seconds in normal mode to enter the
setting mode.
24 Hr starts flashing.
Press the /CH or /UNIT button to choose 12 HR (PM appears on the dis-
play after 12h) or 24 HR system.
Confirm with the MODE/ENTER button.
The setting sequence is shown as follows: Hours, minutes, year, month/
day sequence (American version) or day/month (European version),
month, date, the language for the weekday. Press the /UNIT or /CH
button to adjust it.
Day-of-week language: English (E), German (G), French (F), Spanish (S)
and Italian (I).
Press the MODE/ENTER button again to return to normal mode.
When the DCF reception is activated, the manually set clock will be over-
written by a successfully reception of the DCF time.
7.2 Recall of time, weekday, alarm time and date
Press the MODE/ENTER button in normal mode to change the display
between:
Time with seconds
Time with weekday
1. Alarm time
2. Alarm time
Date
7.3 Setting of the alarm
Press the MODE/ENTER button in normal mode, until the flashing 1 for
the first alarm time appears.
0:00 or the last adjusted alarm time appears.
You can now adjust the first alarm time.
Press and hold MODE/ENTER button.
The hour digit is flashing. Press the /CH or /UNIT button to adjust
hours.
The alarm symbol appears on the display.
Press the MODE/ENTER button again and you can adjust the minutes with
the /UNIT or /CH button.
Confirm the settings with the MODE/ENTER button.
The alarm for the first alarm time is activated.
Press the MODE/ENTER button again.
2 for the second alarm time is flashing.
0:00 or the last adjusted alarm time appears.
Set the alarm time for the second alarm in the same way.
TFA_No. 35.1122_Anl. 07.09.2012 14:18 Uhr Seite 10
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for TFA 35.1122 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of TFA 35.1122 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info