466142
4
Zoom out
Zoom in
Previous page
1/16
Next page
22
weather station and the transmitter should not be more than 100 meters (see notes on
Positioning and “868 MHz Reception”).
Note:
In the event of changing batteries of the units, ensure the batteries do not spring free from
the contacts. Always wait at least 1 minute after removing the batteries before reinserting,
otherwise start up and transmission problems may occur.
WHEN MORE THAN ONE TRANSMITTER IS USED
1. User shall remove all the batteries from the weather station and transmitters, and wait
60 seconds.
2. Insert the batteries in the first transmitter.
3. Within 2 minutes of powering up the first transmitter, insert the batteries in the weather
station. Once the batteries are in place, all segments of the LCD will light up briefly and
a short signal tine will sound. Following the indoor temperature/humidity and the time
as 0:00 will be displayed. If these information are not displayed on the LCD after 60
seconds, remove the batteries from both units and wait for at least 60 seconds before
reinserting them.
4. The outdoor temperature and humidity data from the first transmitter (channel 1)
should then be displayed on the weather station. Also, the signal reception icon will be
displayed. If this does not happen after 2 minutes, the batteries will need to be
removed from both units and reset from step 1.
5. Insert the batteries in the second transmitter as soon as the outdoor temperature and
humidity readings from the first transmitter are displayed on the weather station.
Note :
User shall insert the batteries into the second transmitter within 45 seconds
after the weather station displays the information of the first transmitter.
6. The outdoor temperature and humidity from the second transmitter and the "channel 2"
icon should then be displayed on the weather station. If this does not happen after 2
minutes, the batteries will need to be removed from all the units and reset from step 1.
7. Insert the batteries in the third transmitter as soon as the "channel 2" icon and outdoor
data are displayed on the weather station. Then within 2 minutes, the channel 3
outdoor data from the third transmitter will be displayed and the channel icon will shift
back to "1" once the third transmitter is successfully received. If this is not happen, user
shall restart the setting up from step 1.
Note :
User shall insert the batteries into the third transmitter within 45 seconds after
the weather station displays the information of the first transmitter. Or immediately after
reception of the second transmitter is finished.
8. In order to ensure sufficient 868 MHz transmission however, the distance between the
weather station and the transmitter should not be more than 100 meters (see notes on
Positioning and “868 MHz Reception”).
IMPORTANT:
Transmission problems will arise if the setting for additional sensors is not followed as
described above. Should transmission problems occur, it is necessary to remove the
batteries from all units and start again the set-up from step 1.
DCF RADIO CONTROLLED TIME
The time base for the radio controlled time is a Cesium Atomic Clock operated by the
Physikalisch Technische Bundesanstalt Braunschweig which has a time deviation of less
than one second in one million years. The time is coded and transmitted from Mainflingen
near Frankfurt via frequency signal DCF-77 (77.5 kHz) and has a transmitting range of
approximately 1,500 km. Your radio-controlled weather station receives this signal and
converts it to show the precise time in summer or wintertime.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for TFA 35.1045.IT - Laluna Funk at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of TFA 35.1045.IT - Laluna Funk in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of TFA 35.1045.IT - Laluna Funk

TFA 35.1045.IT - Laluna Funk User Manual - German - 18 pages

TFA 35.1045.IT - Laluna Funk User Manual - Dutch - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info