Manual TFA 30.3000 (page 4 of 23) (English, German, Dutch, French, Italian, Spanish)

647511

Zoom out

Zoom in

1/23

Indoor Temperature: Shows:

* current indoor temperature in degrees Celsius.

* minimum indoor temperature in degrees Celsius.

* maximum indoor temperature in degrees Celsius.

Outdoor Temperature: Shows:

* current outdoor temperature in degrees Celsius.

* minimum outdoor temperature in degrees Celsius.

* maximum outdoor temperature in degrees Ceisius.

* An arrow shows the temperature trend, i.e. whether

it rises or falls with respect to the last reading.

* When the minimum and maximum outdoor temperatures

are displayed, the time that these temperatures were

received by the Temperature Station are also shown on

the time display for 16 seconds from when the minimum

or maximum modes were entered. After 16 seconds the

time display will revert to the current time but the minimum

or maximum temperature will continue to be displayed.

1211

Temperature Transmitter:

The LCD display shows the current temperature at the location it is in. The temperature is measured and

transmitted every 30 seconds and at each transmission the antenna icon (Y) will light briefly.

Wall mounting or table stand - Temperature Station

The Temperature Station is supplied with the table stand already attached to avoid the user having to

attach this. To remove this pull the stand away from the unit.

Alternatively the unit can be attached to a wall by using the hanging hole on the back of it. To hang it on

a wall correctly, the screw head should extend out of the wall by about 5mm. The unit is then placed on

this screw via its hanging hole so that it locks on.

The Temperature Transmitters range may be affected by the temperature. If it has been extremely cold

(under -25˚C) for an extended period of time then the temperature signal that is sent to the Temperature

Station may not be transmitter as far. Please bear this in mind when placing the Temperature Transmitter.

The LCD contrast on the unit may also be reduced and batteries are reduced in power during extended

sub-zero periods.

Please Note: The temperature transmissions will not be able to be received by the Temperature Station if

any other 433MHz products(headphones, speakers etc.) are working at the same time in the same area as

they both use the same frequency. Once the other product has been turned off the Temperature Station

will again receive the outdoor transmissions and this will then be displayed within a few minutes.

Wall mounting - Temperature Transmitter

The Temperature Transmitter is supplied with a holder that may be attached to a wall with the three

screws supplied. To attach to the wall follow the steps below:

1. Mark the wall using a pen through the holes in the holder to obtain exact drilling position.

2. Drill holes in the wall at points marked out.

3. Screw holder onto wall.

There is also double sided tape included with the wall mount. This can be used instead of drilling. Please

mount this on a smooth surface instead of a brick one. The surface can, however, affect the transmission

range, for example: if the unit is attached to a piece of metal then it may either reduce or increase the

transmitting range. For this reason we recommend not placing the unit on any metal surface or in any

position where a large metal surface is in the immediate proximity (garage doors, double glazing etc.).

Before securing in place please ensure that the Temperature Station can receive the signal from the

Temperature Transmitter from where you wish to situate them both.

The Temperature Transmitter clicks in or out of the wall holder easily. When inserting or removing the

Temperature Transmitter from the wall holder please hold both units securely whilst doing so.

Maintenance

* Extreme temperatures, vibration and shock should be avoided as they may damage both units.

* Clean displays and units with a soft damp cloth only. Do not use solvents or scouring agents as they

may mark the displays and casings.

* Do not submerge the Temperature Station in water.

* Immediately remove low power batteries to avoid leakage and damage to either unit. Replace only

with new batteries of the recommended size.

* Do not subject the units to unnecessary heat or cold, i.e. place in oven or freezer.

* Do not try and repair the unit, please return it to its point of purchase for repairing by a qualified

person. Opening the unit and tampering with it may invalidate its guarantee.

Problems and Solutions

Problem Solution

"---"shows in Minimum or Hold down together the "RESET" and "INDOOR"

Maximum display section. or "OUTDOOR" buttons to set recorded temperature extremes

to current air temperature.

"---" shows on outdoor Move Transmitter closer to the unit or change the batteries as

temperature display. the temperature has not been received in three consecutive

tries by the Temperature Station. Press "RESET" button until

"AUSSEN" flashes in the display.

Clock does not receive the time. Out of Frankfurt transmitter range. Set clock manually. Button

pressed while the units were synchroizing. Remove batteries

to retry and do not press any buttons.

None or not all of the Batteries not inserted correctly. Re-insert. Batteries

segments light up when do not have significant power in them. Replace

batteries inserted in the with new batteries.

Temperature Station.

INNEN M A X

MAX. TEMPERATURE

DISPLAY

TEMPERATURE

AUSSEN MI N

MIN. TEMPERATURE

DISPLAY

TEMPERATURE

TREND INDICATOR

TEMPERATURE

TRANSMISSION

ANTENNA

CELSIUS

TEMPERATURE

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of TFA 30.3000 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,37 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

TFA 30.3000 Manual

Product: