636769

Texas SNOW BUSTER 390 Manual

12
Zoom out
Zoom in
Previous page
1/14
Next page
Turn on and shut off the machine:
Warning! Do not put hands or feet near auger housing or discharge opening.
1. Press the safety lock button while triggering the throttle.
2. Keep holding the lever and release the safety lock button.
3. Release the throttle lever to stop the machine
Snow clearing
It is recommended that the snow is cleared in a specific pattern to make sure that the whole area
swept thoroughly. The two recommended patterns below ensure that all snow is swept in one go
thereby you will avoid to remove the snow that has already been removed.
Pattern 1: Throw the snow to the right or left side where it is possible, as on a long driveway it is
advantage to start in the middle. Plow from one end to the other, throwing snow to both sides.
Pattern 2: If the snow can only be thrown to one side of the driveway or sidewalk start on the
opposite side.
Position the discharger in safe direction and the right angle, away from you and bystanders. Direct
the snow to the right or to the left up and down by altering the chute mouth. It is recommended to
throw the snow downwind, and slightly overlap each round.
After clearing the snow, let the auger run for a couple of minutes so that the rotating parts doesn’t
freeze. Then switch off the motor, wait for all moving parts to stop, and wipe the ice and snow off
the appliance.
Warning! To avoid serious personal injury, do not use hands or feet to unclog chute.
Maintenance and storage
Frequent maintenance and cleaning will extend service life of the machine.
Always disconnect the power supply directly on the socket before conducting any
maintenance or repair.
Remove and clean snow, ice and debris from the auger and housings using a humid cloth
and a soft brush. Never wet or spray water on the machine!
Do not use detergents or solvents as these could cause irreparable damage to the
machine. Chemicals can destroy the plastic parts.
Lubricate the metal parts with environmentally friendly oil. This will prevent the parts
corrode during storage
Store the machine in a dry room out reach of kids.
… 12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas SNOW BUSTER 390 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas SNOW BUSTER 390 in the language / languages: English, Danish as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info