636640
15
Zoom out
Zoom in
Previous page
1/62
Next page
8
Mulching plug: Illustration M7-2
1. Insert the mulching plug and remove side
discharge guard, if you want to mow with mulching
functionality.
NB Don’t use the grass collector
Important: Remember to remove the mulching plug,
when using the grass collector.
Side discharge guard: Illustration M7-3*
1. Lift the side guard and insert side discharge guard.
Then insert the mulching plug in rear discharger to
mow with side discharge function. NB Don’t use the
grass collector
* Note: Not all models do have side discharge guard
Cable Adjustment
The following cables may be necessary to readjust:
Illustration A1
1. Cable for drive
2. Cable for engine brake
3. Cable for throttle cable
Note: The choke cable cannot be adjusted!
Adjusting the drive cable: Illustration A1-1
If you experience slack in the drive cable, this can be
solved simply by tighten or loosen the bolt on the cable.
1. Tighten turning clockwise - loosen the cable.
2. Tighten turning anti clockwise - tighten the cable.
Adjusting the engine brake cable: Illustration A1-2
If you experience slack in engine brake cable, this can
be solved simply by tighten or loosen the bolt on the
engine block.
Adjusting the throttle cable: Illustration A1-3
If you experience slack in revolution cable, this can be
solved simply by tighten or loosen the bolt on the
engine block.
Battery (Electric starter)*
Charge the battery before use
Before the electric start function is used, the battery
must be charged for 5 hours. Put the charger plug into
the hole in the battery and connect the charger to a
power supply. See illustration. A4
Charging during the season
The battery is charged a little during use, buy it will
likely be necessary to charge the battery a couple of
times during the season - depending if the number of
start/stops of the engine. Put it for charging for around 5
hours.
Storage of battery
The battery must always be stored dry and warm during
the winter. Never expose it for low temperatures.
Charge the battery completely before storing and then
place the lawn mower in a place where it is not exposed
to frost. Alternatively cover the battery with a thick
carpet or similar, If the mower is in a shed/garage
where there may be cold.
Charge the battery 1-2 times during the winter (at least
every 3
rd
month) to make sure the battery keeps it full
capacity.
Incorrect storage can damage the battery, and is not
covered by warranty.
* Note: Not all models have electric starter
Operation
Always check and refill oil before the start!
Read and apply the instructions given in the
enclosed start guide!
The oil level should always be between min. and max
on the dipstick. Fill with SAE-30 oil. There should be
total 0.6 liter oil in the engine. Use only unleaded 95
octane fuel to the engine. Never overfill the tank.
Cutting height adjustment: Illustration F1
(the illustrations may vary from your actual model)
The mower has 6 different heights. The cutting height
ranges from 28 mm to 75 mm
Start: Never start the mower directly on long grass.
Recoil with primer, illustration F2
1. Push the primer several times, first time push 1-3
times, if necessary supplement with up to 3-5
times.
Note: It is not possible to drown engine
2. Hold the handlebar for the engine brake; this will
release the engine brake.
3. Pull the recoil starter gently until you feel resistance
in the rope, then pull quickly and energetic. Do not
at any time let go of the recoil starter but slide it
gently into starting position.
4. Hold the bar for self-propelled in order to start
mowing
Recoil with choke, throttle lever illustration F3-A
1. By cold engine set the choke lever on ”Choke”- By
warm engine set the choke lever on ”Run”
2. Move the throttle lever to full “Rabbit”(A)
3. Hold the handlebar for the engine brake; this will
release the engine brake.
4. Pull the recoil starter gently until you feel resistance
in the rope, then pull quickly and energetic. Do not
at any time let go of the recoil starter but slide it
gently into starting position.
5. Adjust the throttle lever if necessary and return the
choke lever in the ”run” position. (only cold engine)
6. Hold the bar for self-propelled in order to start
mowing.
Electrical starter, illustration F3-B
1. By cold engine set the choke lever on ”Choke”- By
warm engine set the choke lever on ”Run”
2. Move the throttle lever to full “Rabbit” (A)
3. Hold the handlebar for the engine brake; this will
release the engine brake.
4. Push the Electrical start button (B)
5. Adjust the throttle lever if necessary and return the
choke lever in the ”run” position. (only cold engine)
6. Hold the bar for self-propelled in order to start
mowing.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas Razor 5170 TR-WE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas Razor 5170 TR-WE in the language / languages: English, German, Dutch, Danish, French, Polish as an attachment in your email.

The manual is 7,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info