636634
55
Zoom out
Zoom in
Previous page
1/62
Next page
Troubleshooting
If your problem is not described above, please contact an approved service centre or Texas A/S.
Difficult to start
Problem
Cause
Solution
Generally difficult to start
Wrong starting procedure
Follow the starting instructions in the manual precisely.
The start cable is very tight (will not start)
The brake handle is not being activated
The machine is placed in high grass
Activate the brake handle and pull the start cord.
Move the machine away from the high grass and repeat the start procedure.
Set the height adjustment in the highest position, so that the blade is lifted free of
the grass.
The machine will not start when the start cord
is pulled or the electric start button is pushed
(or the starter "clicks" when attempting an
electric start)
The brake handle is not being activated
The wires are not connected to battery
The brake cable is incorrectly adjusted
The machine is standing in high grass
Engine is not primed before starting
The choke is not in the correct position
No more gasoline in fuel tank
The gasoline is more than 3 months old
Activate the engine brake handle and press the electric start button.
Check that the wires are connected from the battery to the motor and start button.
Adjust the engine brake cable, following the instructions in the manual.
Move the machine away from the high grass to start it.
Tip the machine when starting.
Set the height adjustment in the highest position, so that the blade can run freely.
Push the primer 1-3 times before starting.
Move the choke lever to a different position.
Check and fill fuel tank with gasoline.
Empty the fuel tank and carburettor from old gasoline, and fill with new gasoline.
No ignition spark (cannot start)
The spark plug cap is loose
The spark plug is damp or dirty
Incorrect gap between the spark plug and
the electrode
The air filter is dirty or defective
Check that the cap is firmly attached to the spark plug.
Check that there is no dirt on the spark plug, following the instructions in the
manual.
Check and adjust the spark plug gap, following the instructions in the manual.
Alternatively, replace the spark plug.
Check the air filter for dirt and clean it, following the instructions in the manual.
The mower starts, but runs unevenly
Problem
Cause
Solution
Insufficient engine revolutions
Lever is in the "Choke" position
The throttle lever is set for "Turtle "
Set the lever in the "Run" position.
Set the throttle lever for "Rabbit".
The back wheels are not pulling, or only very
little
The clutch cable is too tight/too loose
The ratchets in the rear wheels are worn
Adjust the clutch cable, following the instructions in the manual.
Replace the ratchets.
The engine runs irregularly and/or its
performance becomes poor as you are
working
The spark plug cap is loose
The spark plug is dirty
Incorrect gap between the spark plug and
the electrode
The air filter is dirty or defective
Evaporation of fuel in the carburettor
Loose throttle cable
Dirt in the carburettor
Check that the cap is firmly attached to the spark plug.
Check that the spark plug is clean and not damaged, following the instructions in the
manual.
Check and adjust the spark plug gap, following the instructions in the manual.
Check the air filter for dirt and clean it, following the instructions in the manual.
Wait a few minutes, and then try to start again.
Tighten the throttle cable, following the instructions in the manual.
Clean the carburettor.
The engine will not stop
Problem
Cause
Solution
The machine does not stop after 5 seconds
The engine brake cable runs too tightly
Check and adjust the engine brake cable, following the instructions in the manual.
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas Razor 5120 TR-W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas Razor 5120 TR-W in the language / languages: English, German, Dutch, Danish, French, Polish as an attachment in your email.

The manual is 7,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info