636734

Texas Power Saw 3000 Manual

9
Zoom out
Zoom in
Previous page
1/31
Next page
Danger of cutting or crushing the hand exists: never touch hazardous areas while
the wedge is moving.
Never remove a log trapped in the wedge with your hands. Never touch the
moving parts of the machine when the machine is on.
Inspect for damaged parts. Before further use of the machine, a guard or any
other part that may be damaged shall be inspected to ensure that it will operate
properly and perform in its intended function. Check for alignment of the moving
parts, breakage of parts, mounting, or any other conditions that may affect its
operation. A guard or other parts that are damaged should be properly repaired or
replaced.
Keep guards and slide bars in place and in working order.
Always remove adjusting keys/spanners etc. Form habit of checking to ensure that
keys and spanners etc. are removed from the machine before turning it on.
Never use the machine under influence of drugs, alcohol or medication.
You must never stand on the machine, injury could occur in case of a fall.
Never let the machine run unattended. Disconnect the power when you leave the
machine.
Stop the engine when adjusting, changing parts or repairing the machine.
Do not wear any jewellery or loose clothing that could be snagged by the log
splitter.
The pressure must not be adjusted.
The user shall operate the log saw with both hands.
Never split two logs at once, they can tilt and create danger.
Never place a new log on the machine before you’ve finished the previous as this
can be very dangerous.
Draw attention to the blade always being sharp, replace when necessary.
Electric motor
It is important that the saw is connected to a corresponding current, as described on the
machines type tag.
If the cord is less than 25 meters the copper cross section must be minimum 1,5mm
2
. If
the cord is more than 25 meters the cross section must be minimum 2,5mm
2
. Note,
however, that there may be national differences with regard to type of plug. Therefore
check that the plug which is being used respects the demands of your country’s legislation
concerning earth connection. A 16 Ampere fuse shall be used.
Motor brake
The electric motor is equipped with a motor brake which automatically shuts the motor off
at overload.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas Power Saw 3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas Power Saw 3000 in the language / languages: English, German, Dutch, Danish, Finnish as an attachment in your email.

The manual is 0,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info