709628
41
Zoom out
Zoom in
Previous page
1/52
Next page
29
Messages
Problem or
message
Possible solutions
Device not
found
Make sure the data cable from the calculator
is properly connected to the network
connector.
Ensure that the access point is connected and
its power adapter is plugged in.
Problem or
message
Possible causes or solutions
Device is
incorrectly
configured
An access point
was located, but
one or more
configuration
parameters are
set incorrectly.
Troubleshoot the Access Point procedure to
reconfigure this device. (See “Setting up your
TI-Navigator™ network the first time” on
page 11.)
Device did not
respond, or
Device not
found
No access point
was located by
the system. The
hubs cannot be
configured until
this is corrected.
The access point has not yet been added to
the system.
The access point is turned on but still
initializing.
Run Network Manager and click on
Check
Access Point
.
Cannot add the
access point to
the network
The access point is not in a receptive state. If
its configuration has been corrupted, reset
the access point to the original settings. You
will need to reconfigure the access point and
add all the hubs to the network again.
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas Instruments TI-Navigator 3.2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas Instruments TI-Navigator 3.2 in the language / languages: English as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Texas Instruments TI-Navigator 3.2

Texas Instruments TI-Navigator 3.2 Additional guide - English - 286 pages

Texas Instruments TI-Navigator 3.2 Quick start guide - English - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info