514296
63
Zoom out
Zoom in
Previous page
1/113
Next page
Chapter 4
SLAU292DNovember 2009Revised March 2011
eZ430-Chronos Hardware
4.1 Programming/Reprogramming the eZ430-Chronos Watch: Disassembly and
Assembly of the Housing
To program and debug code on the CC430, it needs to be connected to a PC with a JTAG interface. The
eZ430-Chronos kit includes the eZ430-RF JTAG interface for that purpose. It can only be connected to the
eZ430-Chronos watch after the watch electronic module is removed from its housing. This chapter
describes how to remove the watch electronics from the housing and how to assemble it again.
NOTE: Videos with detailed instructions can be found on www.ti.com/chronos and the CD that is
included in the kits.
4.1.1 Disassembly of eZ430-Chronos Watch
1. Open screws on back of watch. Use the included Phillips screwdriver
2. Remove metal back of watch. Be careful not to damage the gasket between the watch and the metal
back
3. Lift out the watch module. Use the screwdriver as shown in Figure 4-1.
Figure 4-1. Removing Watch Module from Housing
63
SLAU292DNovember 2009Revised March 2011 eZ430-Chronos Hardware
Submit Documentation Feedback
© 2009–2011, Texas Instruments Incorporated
63


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas Instruments eZ430-Chronos at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas Instruments eZ430-Chronos in the language / languages: English as an attachment in your email.

The manual is 7,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info