636751
38
Zoom out
Zoom in
Previous page
1/42
Next page
www.texas.dk
38
9. Bedienung des Gerätes
10. Austausch des Messers
Den Kantenschneider zur Seite legen, so dass das Mes-
ser nach oben zeigt. Sorgen Sie dafür, dass das Gerät
auf einem sauberen Untergrund liegt, damit kein
Schmutz in das Luftansaugsystem des Motors gelangt.
Nehmen Sie den Zündkerzenstecker ab.
Die große Scheibe mit einem Gabelschlüssel festhalten,
während die Mutter mit einem weiteren Gabelschlüssel
abgeschraubt wird.
Scheibe und Messer abnehmen.
Den Arbeitsbereich auf Kabel, Steine und andere Gegenstän-
de untersuchen, die beschädigt werden können bzw. ihrer-
seits das Gerät beschädigen können.
Schneidtiefe auf 20 mm einstellen. Ist der Boden sehr hart
oder sehr weich, kann eine andere Höheneinstellung erforder-
lich werden.
Die Peillinie dient zum Einhalten der Richtung.
Senken Sie den Kantenschneider langsam ab und geben Sie
dabei Gas.
Das Gerät langsam voranschieben und die Richtung beibe-
halten.
Ist z. B. an einer Plattenkante entlang zu schneiden, wird die
Kantenführung aktiviert, die leicht gegen die Kante zu drücken
ist. Siehe o. a. Beschreibung zum Thema „Kantenführung“.
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas EC 2600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas EC 2600 in the language / languages: English, German, Danish, Norwegian as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info