562320
9
Zoom out
Zoom in
Previous page
1/32
Next page
• IP 7000 BR 9
The terminals are each marked red (+) and black (–).
Make sure the polarity is correct!
Connect the like coloured terminals. Otherwise
the sound quality will suffer. The strands of the
speaker single wire are marked with different colours
or shapes.
Split the single wire down to
approx. 30 mm on both ends and
strip approx. 10 mm of insulation
off of each cord. Twist the single
wire so that no strands are protrud-
ing.
Turn the connector terminal 24 counter-
clockwise until loose. Run the stripped
cable end into the now visible hole.
Close the terminal by turning it counter-
clockwise. The cable has now been
clamped in place.
Television/projector
You can connect a television set and/or projector to the
following outputs:
1820
1514
18 HDMI OUT
Digital picture and audio signals via a HDMI cable.
15 Y CB/PB CR/PR
Analogue component picture signal via a triple RCA
cable. Pay attention to the colour of the jacks (green, blue
and red) when connecting. Audio is emitted via the RCA
jacks 20AUX OUT” as stereo downmix.
14 VIDEO
Analogue picture signal (FBAS) via an RCA cable. The
audio is emitted via the jacks 23AUX OUT” in this case
as well.
You should preferably use the HDMI output 18 as only
the signals of HDMI inputs 1 and 2 are emitted here. The
HDMI inputs may not be used when connecting via one
of the other outputs.
Inputs for source devices
The receiver offers you two inputs for digital HDMI
picture and audio sources (HDMI 1 + 2). An optical and
coaxial digital audio input and analogue audio input
(AUX IN) are also available.
You can also connect the audio output of your television
set to one of these audio inputs in order to listen to audio
from the receiver when you watch television shows. See
the operating instructions of your television set for more
information.
171923 22
17 HDMI 1 and 2
You can connect a source device with a digital picture
and audio signal to each of these inputs. You will need a
HDMI cable for this.
Important
You can only use these HDMI inputs if the
playback device (TV or projector) is connected
via HDMI.
22 COAXIAL
You can connect the coaxial digital audio output of a
source device here. You will need a coaxial cable with
RCA plugs to do so.
23 OPTICAL
You can connect the optical digital audio output of a
source device here. You will need an optical cable with a
TOSLINK plug for this. Your source device requires either
an optical 3.5 mm plug or a TOSLINK plug.
19 AUX IN
You can connect a source device with analogue audio
here. You will need a stereo RCA cable for this (L and R).
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teufel IP 7000 BR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teufel IP 7000 BR in the language / languages: English as an attachment in your email.

The manual is 5,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info