562467
8
Zoom out
Zoom in
Previous page
1/20
Next page
8 • DecoderStation 7
Setup
Location tips
Select a stable, level base.
Make sure that the environment is clean and free from
dust.
Avoid placing the unit close to sources of heat or in
direct sunlight.
Do not place any heavy objects on the Decoder-
Station 7 or the cables.
The receiver for signals from the remote control is located
at the front of the unit. You should therefore set up the unit
so that you can see it from your sitting position.
You will need two micro-type or AAA batteries with 1.5
Volt (included in the product contents) in order to operate
the remote control.
Inserting batteries
Gently press down the arrow on the battery compart-
ment cover on the back of the remote control. Push the
cover down and out.
If applicable, remove any old batteries (please observe
the disposal notes on page 20).
Insert the batteries in the battery compartment as
shown in the figure.
Place the cover back on the compartment and push it
closed.
Functionality
The remote control relays the control signals by means of
infrared light. For this, you will have to point the remote
control at the DecoderStation 7. The infrared receiver is
located on the front side. Make sure that the infrared light
is not obstructed by objects.
Remote control
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teufel DecoderStation 7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teufel DecoderStation 7 in the language / languages: English as an attachment in your email.

The manual is 2,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info