742908
123
Zoom out
Zoom in
Previous page
1/139
Next page
118
Advanced
Settings
Log Severity
Level
Configure severity level of logs which are sent to the log server.
Only logs with severity level higher than the specified one can be
sent to the log server.
Server IP
Enter the server IP address here.
Port
Display the UDP port number which is used for sending/receiving
system logs. The default is 514 and cannot be modified.
Tip:
In order to verify that system logs can be sent to the remote log server, click
Administration > System Configuration > System Info to configure IP address, subnet
mask and gateway for this switch.
2 Network Diagnostics
This section, Cable Check-up, Ping Check-up and Tracert Check-up included, is used for
troubleshooting network malfunction.
2.1 Cable Check-up
On this device, you can test current cabling situations on all Ethernet interfaces, pair A, B,
C, D connection status and pair length included. Click Maintenance > Network
Diagnostics > Cable Check-up to enter page below:
Tip:
The pair length is the total length of the twisted cable, not the length of its cable skin.
There may be errors in the checking length.
The test result is for reference only. In some special cases, test errors or failure may
occur.
123


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tenda TEG3210P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tenda TEG3210P in the language / languages: English as an attachment in your email.

The manual is 8,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info