742885
29
Zoom out
Zoom in
Previous page
1/43
Next page
P200 200Mbps PowerLine Mini Adapter
25
“Save” with the option enabled applies the QoS settings to all adapters
discovered on the network and authenticated by the Utility.
Save: Click it to save settings to corresponding adapter.
Cancel: When clicked, current settings will not be saved.
Tips
1. The default QoS policy for the device includes 8 ToS rules and 1 IP
multicast rule, which will be deleted if the QoS-Quick Setup functionality is
activated.
2. You can only apply a single option in Quick Setup to an adapter at a time.
When you switch from one option to another, the former will be deactivated
automatically.
3. Activating application/service under QoS-Quick Setup does not remove
existing MAC/IP based QoS entry.
4. There is a limit on the number of configurable QoS entries for each data
type: up to 14 entries respectively for MAC address based data (Eth Source
Address+ Eth Dest Address) and IP address based data (IPv4 Source Address
+ IPv4 Dest address), up to 8 entries for IPv4 Precedence, and 16 entries for
port based data (TCP Source Port + TCP Dest Port + UDP Source Port + UDP
Dest Port). Errors will be reported when configured entries exceed limit and
such entries will not be saved.
5. The QoS feature does not increase your existing bandwidth. It prioritizes
specified data over your existing bandwidth.
6. Advantages of the QoS feature are typically seen on congested networks.
Normally, Powerline network is not confronted with congestion as powerline
transmission rate reaches up to 200M while ADSL Internet connection rate is
only 12M at most and yet shared by multiple users. So, you may not
experience obviously tremendous benefits from your QoS settings if you are
enjoying a smooth network. However the QoS feature does bring you more
or less benefits, they are just not as tremendous as in a congested network.
7. If you set a PCs MAC priority level to “0”, IP priority to “2” and enabled
Surfing priority in QoS--Quick Setup section, then adapter will consider the
MAC priority of “0” a currently valid priority for packets received from such
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tenda P200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tenda P200 in the language / languages: English as an attachment in your email.

The manual is 1,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info